HIRSCHMANN-GENERIC-ERROR-MIB
File:
HIRSCHMANN-GENERIC-ERROR-MIB.mib (5723 bytes)
Imported modules
Imported symbols
Defined Values
hmRedundancyConflict |
1.3.6.1.4.1.248.16.2.1 |
Conflict Redundancy Protocols: Cannot enable {0} because of enabled {1}. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmRedundancyConflictPort |
1.3.6.1.4.1.248.16.2.2 |
Conflict Redundancy Protocols: Cannot enable {0} because of enabled {1} on Ring Port {2}. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmMaxNumExceeded |
1.3.6.1.4.1.248.16.2.3 |
Max. number exceeded for {0}. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmAlreadyCreated |
1.3.6.1.4.1.248.16.2.4 |
Instance already created. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmRedundancyConflictFpgaPort |
1.3.6.1.4.1.248.16.2.5 |
Conflict Redundancy Protocols: Cannot enable {0} on configured ports. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmVlanUnawareConflict |
1.3.6.1.4.1.248.16.2.6 |
Cannot enable {0} because {1} is enabled. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmRedundancyConflictPortShort |
1.3.6.1.4.1.248.16.2.7 |
Cannot enable {0} on configured ports. Reason: {1} |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmTableFullError |
1.3.6.1.4.1.248.16.2.8 |
{0} table is full. Maximum allowed: {1}. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmGeneralConflict |
1.3.6.1.4.1.248.16.2.10 |
{0} conflicts with {1}. {2}. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmGeneralExceededRange |
1.3.6.1.4.1.248.16.2.11 |
The {0} is exceeding the range. Maximum permissable range is {1}..{2}. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmMgmtUdpPortInUse |
1.3.6.1.4.1.248.16.2.200 |
Given UDP port is already in use. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmMgmtTcpPortInUse |
1.3.6.1.4.1.248.16.2.201 |
Given TCP port is already in use. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmMgmtIPAddressConflictWithMgmtIP |
1.3.6.1.4.1.248.16.2.202 |
Given IP address/netmask {0}/{1} conflicts with the management IP address/netmask. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmMgmtIPAddressConflictWithOobIP |
1.3.6.1.4.1.248.16.2.203 |
Given IP address/netmask {0}/{1} conflicts with the out-of-band management IP address/netmask. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmMgmtIPAddressConflictWithRouterIP |
1.3.6.1.4.1.248.16.2.204 |
Given IP address/netmask {0}/{1} conflicts with a routing interface IP address/netmask. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hm2NetIPAddrInvalid |
1.3.6.1.4.1.248.16.2.300 |
The {0} IP address is not valid. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hm2NetIPAddrAndGateway |
1.3.6.1.4.1.248.16.2.301 |
Management IP address and gateway are not on the same subnet. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hm2NetIPAddrAndSubnet |
1.3.6.1.4.1.248.16.2.302 |
The {0} IP address and subnet mask combination is not valid. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hm2NetPrefixLengthInvalid |
1.3.6.1.4.1.248.16.2.303 |
Subnet mask must have contiguous ones and be no longer than 30 bits. |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|
hmMgmtSEInfoValueChanged |
1.3.6.1.4.1.248.16.3.1 |
Note: Value changed from {0} to {1} |
Status: current |
Access: read-only |
OBJECT-IDENTITY |
|
|
|