CISCO-LWAPP-U3INTERFACE-MIB
File:
CISCO-LWAPP-U3INTERFACE-MIB.mib (12569 bytes)
Imported modules
Imported symbols
Defined Types
CLU3InterfaceWlanEntry |
|
SEQUENCE |
|
|
|
|
cLU3InterfaceWlanStatus |
TruthValue |
|
|
cLU3InterfaceReportingInterval |
Unsigned32 |
|
CLU3InterfaceClientEntry |
|
SEQUENCE |
|
|
|
|
cLU3InterfaceClientSkipCount |
Unsigned32 |
|
|
cLU3InterfaceClientKeepAliveCount |
Unsigned32 |
|
|
cLU3InterfaceClientEstimatePeriod |
Unsigned32 |
|
|
cLU3InterfaceClientBackoffTimer |
Unsigned32 |
|
|
cLU3InterfaceClientThroughput |
Unsigned32 |
|
|
cLU3InterfaceClientThreshold |
Unsigned32 |
|
|
cLU3InterfaceClientEarlyLift |
Unsigned32 |
|
Defined Values
ciscoLwappU3InterfaceMIB |
1.3.6.1.4.1.9.9.852 |
U3 Interface between WLC and CWC(Cellular WLAN Controller)
is present to support Real-Time Traffic Steering(RTTS) of
client between 3GPP networks and WLAN. Throughput needs to
be calculated at WLC and shared with the CWC to take decision
to steer the traffic to WLAN or not. It is also defined to
reject client in case if throughput is not satisfactory
along with periodic updation of throughput.
GLOSSARY
Access Point ( AP )
An entity that contains an 802.11 medium access
control ( MAC ) and physical layer ( PHY ) interface
and provides access to the distribution services via
the wireless medium for associated clients.
LWAPP APs encapsulate all the 802.11 frames in
LWAPP frames and sends it to the controller to which
it is logically connected to.
Central Controller ( CC )
The central entity that terminates the LWAPP protocol
tunnel from the LWAPP APs. Throughout this MIB,
this entity also referred to as 'controller'.
Light Weight Access Point Protocol ( LWAPP )
This is a generic protocol that defines the
communication between the Access Points and the
controllers.
Cellular WLAN Controller ( CWC )
A decision making entity to steer traffic over LTE or
WLAN. |
MODULE-IDENTITY |
|
|
|
cLU3InterfaceWlanEntry |
1.3.6.1.4.1.9.9.852.1.1.1.1 |
Each entry in this table represents the configuration
attributes of u3-interface on a WLAN. |
Status: current |
Access: not-accessible |
OBJECT-TYPE |
|
|
|
|
CLU3InterfaceWlanEntry |
|
|
cLU3InterfaceWlanStatus |
1.3.6.1.4.1.9.9.852.1.1.1.1.1 |
This object specifies the status of u3-interface on a
particular WLAN.
A value of 'true' indicates that u3-interface is
enabled on a WLAN.
A value of 'false' indicates that u3-interface is
disabled on a WLAN. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
TruthValue |
|
|
cLU3InterfaceReportingInterval |
1.3.6.1.4.1.9.9.852.1.1.1.1.2 |
This object specifies the interval at which AP needs
to send throughput details of all the U3 interface
clients on a particular WLAN to the WLC. Reporting
interval range is 30 - 90 seconds. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
Unsigned32 |
|
|
cLU3InterfaceClientEntry |
1.3.6.1.4.1.9.9.852.1.1.2.1 |
Each entry in this table represents the U3 interface
clients attributes.
Some of these attributes will be sent by the CWC
and some of them will be evaluated at the WLC. |
Status: current |
Access: not-accessible |
OBJECT-TYPE |
|
|
|
|
CLU3InterfaceClientEntry |
|
|
cLU3InterfaceClientSkipCount |
1.3.6.1.4.1.9.9.852.1.1.2.1.1 |
This object represents the number of times WLC can
skip informing about estimated throughput of
a U3 interface client to CWC. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Unsigned32 |
|
|
cLU3InterfaceClientKeepAliveCount |
1.3.6.1.4.1.9.9.852.1.1.2.1.2 |
This object represents the maximum number of times
WLC can skip reporting throughput of a U3 interface
client to CWC when throughput is greater than the
threshold represented by cLU3InterfaceClientThreshold. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Unsigned32 |
|
|
cLU3InterfaceClientEstimatePeriod |
1.3.6.1.4.1.9.9.852.1.1.2.1.3 |
This object represents the interval at which WLC has
to report the estimated throughput of a U3 interface
client to CWC. This value is sent by CWC to WLC. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Unsigned32 |
|
|
cLU3InterfaceClientBackoffTimer |
1.3.6.1.4.1.9.9.852.1.1.2.1.4 |
This object represents the time for which U3 interface
client will not be allowed after U3 interface client
getting rejected for throughput below threshold. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Unsigned32 |
|
|
cLU3InterfaceClientThreshold |
1.3.6.1.4.1.9.9.852.1.1.2.1.6 |
This object represents the minimum threshold throughput
of a U3 interface client. The value of this object
is sent by CWC to WLC.
If the calculated throughput values of the Client is
below the cLU3InterfaceClientThreshold have to be
reported at every time interval specified in
cLU3InterfaceClientEstimatePeriod. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Unsigned32 |
|
|
cLU3InterfaceClientEarlyLift |
1.3.6.1.4.1.9.9.852.1.1.2.1.7 |
This object represents the minimum throughput of
U3 interface client to join the WLAN. The value of this
object is sent by CWC to WLC. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Unsigned32 |
|
|
ciscoLwappU3InterfaceMIBCompliance |
1.3.6.1.4.1.9.9.852.2.1.1 |
The compliance statement for the SNMP entities that
implement the ciscoLwappU3interfaceMIB module. |
Status: current |
Access: read-only |
MODULE-COMPLIANCE |
|
|
|
cLU3InterfaceConfigGroup |
1.3.6.1.4.1.9.9.852.2.2.1 |
This is a collection of objects which can
be configured to control u3-interface parameters. |
Status: current |
Access: read-only |
OBJECT-GROUP |
|
|
|
cLU3InterfaceClientMonitorGroup |
1.3.6.1.4.1.9.9.852.2.2.2 |
This is a collection of objects which can
be used to monitor the U3 interface clients parameters. |
Status: current |
Access: read-only |
OBJECT-GROUP |
|
|
|