TN-LOAM-EXT-MIB

File: TN-LOAM-EXT-MIB.mib (3907 bytes)

Imported modules

SNMPv2-SMI SNMPv2-TC IF-MIB
TRANSITION-SMI

Imported symbols

MODULE-IDENTITY OBJECT-IDENTITY enterprises
RowStatus TruthValue ifIndex
InterfaceIndex tnProducts

Defined Types

TnLOAMIfMgmtEntry  
SEQUENCE    
  tnLOAMIfModeCtrl INTEGER
  tnLOAMIfClearStats INTEGER
  tnLOAMIfMUXState INTEGER
  tnLOAMIfPARState INTEGER

Defined Values

tnLOAMExtMIB 1.3.6.1.4.1.868.2.5.7
The mib module for managing Link OAM (IEEE 802.3ah Clause 57) enterprise extensions.
MODULE-IDENTITY    

tnLOAMNotifications 1.3.6.1.4.1.868.2.5.7.0
OBJECT IDENTIFIER    

tnLOAMObjects 1.3.6.1.4.1.868.2.5.7.1
OBJECT IDENTIFIER    

tnLOAMConformance 1.3.6.1.4.1.868.2.5.7.2
OBJECT IDENTIFIER    

tnLOAMIfMgmt 1.3.6.1.4.1.868.2.5.7.1.1
OBJECT IDENTIFIER    

tnLOAMIfMgmtTable 1.3.6.1.4.1.868.2.5.7.1.1.1
This table has entries which generate an synthetic indentifier for a given interface, VLAN service mapping.
Status: current Access: not-accessible
OBJECT-TYPE    
  SEQUENCE OF  
    TnLOAMIfMgmtEntry

tnLOAMIfMgmtEntry 1.3.6.1.4.1.868.2.5.7.1.1.1.1
A entry in the table represents Link OAM management extension for an interface.
Status: current Access: not-accessible
OBJECT-TYPE    
  TnLOAMIfMgmtEntry  

tnLOAMIfModeCtrl 1.3.6.1.4.1.868.2.5.7.1.1.1.1.1
This object can be used to provision the Link OAM mode for this interface. In auto(1) mode , the interface is set to active/passive depending on if the device is in a chassis or stand-alone. Applicable to Chassis based products. In manual(2) mode lets the user choose the Link OAM mode (active/passive).
Status: current Access: read-write
OBJECT-TYPE    
  INTEGER auto(1), manual(2)  

tnLOAMIfClearStats 1.3.6.1.4.1.868.2.5.7.1.1.1.1.2
This mib variable can be used to clear all Link OAM statisitical counters for this interface.
Status: current Access: read-write
OBJECT-TYPE    
  INTEGER reset(1), doNothing(2)  

tnLOAMIfMUXState 1.3.6.1.4.1.868.2.5.7.1.1.1.1.3
The status of interface's multiplexer state.
Status: current Access: read-only
OBJECT-TYPE    
  INTEGER forward(1), discard(2)  

tnLOAMIfPARState 1.3.6.1.4.1.868.2.5.7.1.1.1.1.4
The status of interface's Parser state.
Status: current Access: read-only
OBJECT-TYPE    
  INTEGER forward(1), loopback(2), discard(3)