CISCO-ETHERNET-ACCESS-MIB

File: CISCO-ETHERNET-ACCESS-MIB.mib (9941 bytes)

Imported modules

SNMPv2-SMI SNMPv2-CONF SNMPv2-TC
IF-MIB CISCO-VTP-MIB CISCO-SMI

Imported symbols

Integer32 MODULE-IDENTITY OBJECT-TYPE
MODULE-COMPLIANCE OBJECT-GROUP TEXTUAL-CONVENTION
ifIndex vtpVlanIndex managementDomainIndex
ciscoMgmt

Defined Types

CeaVlanUNIType  
TEXTUAL-CONVENTION    
  current INTEGER other(1), isolated(2), community(3)

CeaPortEntry  
SEQUENCE    
  ceaPortType INTEGER
  ceaPortCapability BITS

CeaUNIVlanEntry  
SEQUENCE    
  ceaUNIVlanType CeaVlanUNIType

Defined Values

ciscoEthernetAccessMIB 1.3.6.1.4.1.9.9.466
The tables defined by this MIB module contain a collection of managed objects that are general in nature and apply to an edge device in an organizations network, e.g. a Metro Ethernet network. An edge device, is a customer located equipment, this is the first device which will connect the Service Provider's network and map subscriber traffic into the next layer. The access media could be either CAT5 or fiber. The access device (edge device) can be designed for DSL, Ethernet or other technologies, however, this MIB is designed for Ethernet. Terminology: UNI - User to Network Interface NNI - Network to Network Interface. ENI - Enhanced Network Interface. Enhanced UNI port. module/device - In an environment (specifically, in an SNMP context) consisting of a single chassis which can contain multiple cards, the term 'module' refers to a card and the term 'device' refers to the whole chassis. In an environment where multiple chassis are 'stacked' together, the term 'module' refers to a chassis and the term 'device' refers to the whole stack. In an environment containing only a single chassis without removable cards, the terms 'device' and 'module' both refer to the chassis and its contents.
MODULE-IDENTITY    

ciscoEthernetAccessMIBObjects 1.3.6.1.4.1.9.9.466.1
OBJECT IDENTIFIER    

ciscoEthernetAccessMIBConform 1.3.6.1.4.1.9.9.466.2
OBJECT IDENTIFIER    

ceaGlobals 1.3.6.1.4.1.9.9.466.1.1
OBJECT IDENTIFIER    

ceaConfig 1.3.6.1.4.1.9.9.466.1.2
OBJECT IDENTIFIER    

ceaMaxNNIPorts 1.3.6.1.4.1.9.9.466.1.1.1
The max number of interfaces per module for which the ceaPortType can have the value 'nni'. The value of 0 is returned by this object if there is no limitation to the number of NNI ports.
OBJECT-TYPE    
  Integer32 0..512  

ceaMaxUNIVlanCommunityPorts 1.3.6.1.4.1.9.9.466.1.1.2
The maximum number of ports on this device for which the ceaUNIVlanType object can have the value 'community'. The value of 0 is returned by this object if there is no limitation to the number of UNI VLAN Communities.
OBJECT-TYPE    
  Integer32 0..512  

ceaPortTable 1.3.6.1.4.1.9.9.466.1.2.1
This table contains Ethernet port specific information. There exists an entry for each Ethernet port with an ifType of 6 (ethernetCsmacd) in this table. Note that the maximum number of NNI ports that can be configured per module on this device is given by the value of ceaMaxNNIPorts.
OBJECT-TYPE    
  SEQUENCE OF  
    CeaPortEntry

ceaPortEntry 1.3.6.1.4.1.9.9.466.1.2.1.1
A set of Ethernet port specific parameters for a device which can be configured with a mixture of port types defined by the ceaPortType object.
OBJECT-TYPE    
  CeaPortEntry  

ceaPortType 1.3.6.1.4.1.9.9.466.1.2.1.1.1
The current configuration of the port. Only ports that are supported by the ceaPortCapability object can be set. Unspecified port type is any other port type than NNI, UNI or ENI. unspecified = Not UNI, or NNI, or ENI uni = User to Network Interface port type. nni = Network to Network Interface port type. eni = Enhanced UNI port type.
OBJECT-TYPE    
  INTEGER unspecified(1), uni(2), nni(3), eni(4)  

ceaPortCapability 1.3.6.1.4.1.9.9.466.1.2.1.1.2
Types supported by the Ethernet port. If a port doesn't support the port type the ceaPortType will not allow set of the unsupported type. nni = Port supports NNI. uni = Port supports UNI. eni = Port supports ENI.
OBJECT-TYPE    
  BITS nni(0), uni(1), eni(2)  

ceaUNIVlanTable 1.3.6.1.4.1.9.9.466.1.2.2
This table contains UNI VLAN information for all the VLANs which currently exist on this device. The number of UNI ports that can belong to a VLAN type 'community' is limited by the ceaMaxUNIVlanCommunityPorts object.
OBJECT-TYPE    
  SEQUENCE OF  
    CeaUNIVlanEntry

ceaUNIVlanEntry 1.3.6.1.4.1.9.9.466.1.2.2.1
There is an entry in this table for each VLAN that exist on this device.
OBJECT-TYPE    
  CeaUNIVlanEntry  

ceaUNIVlanType 1.3.6.1.4.1.9.9.466.1.2.2.1.1
Indicates the VLAN type defined for the UNI VLAN.
OBJECT-TYPE    
  CeaVlanUNIType  

cEthernetAccessMIBCompliances 1.3.6.1.4.1.9.9.466.2.1
OBJECT IDENTIFIER    

cEthernetAccessMIBGroups 1.3.6.1.4.1.9.9.466.2.2
OBJECT IDENTIFIER    

cEthernetAccessMIBCompliance 1.3.6.1.4.1.9.9.466.2.1.1
Write access is not required.
MODULE-COMPLIANCE    

ceaPortGroup 1.3.6.1.4.1.9.9.466.2.2.1
A collection of managed objects defining port types.
OBJECT-GROUP    

ceaVlanGroup 1.3.6.1.4.1.9.9.466.2.2.2
A collection of managed objects defining VLAN types.
OBJECT-GROUP