CISCO-DMN-DSG-SYSTEMTOOL-MIB
File:
CISCO-DMN-DSG-SYSTEMTOOL-MIB.mib
(3229 bytes)
Imported modules
SNMPv2-SMI
SNMPv2-CONF
CISCO-DMN-DSG-ROOT-MIB
Imported symbols
OBJECT-TYPE
MODULE-IDENTITY
OBJECT-GROUP
MODULE-COMPLIANCE
ciscoDSGUtilities
Defined Values
ciscoDSGSystemTool
1.3.6.1.4.1.1429.2.2.5.8
Cisco DSG System Tool MIB.
MODULE-IDENTITY
systemTool
1.3.6.1.4.1.1429.2.2.5.8.1
OBJECT IDENTIFIER
systemToolBanner
1.3.6.1.4.1.1429.2.2.5.8.1.1
Enable / Disable OSD Banner Messages.
Status: current
Access: read-write
OBJECT-TYPE
INTEGER
disable(1), enable(2)
systemToolReboot
1.3.6.1.4.1.1429.2.2.5.8.1.2
Setting yes(2) reboots the system.
Status: current
Access: read-write
OBJECT-TYPE
INTEGER
writeOnly(1), yes(2)
systemToolFactoryReset
1.3.6.1.4.1.1429.2.2.5.8.1.3
Setting yes( 2 ) performs factory reset of the system.
Status: current
Access: read-write
OBJECT-TYPE
INTEGER
writeOnly(1), yes(2)
systemToolCleanUnusedTables
1.3.6.1.4.1.1429.2.2.5.8.1.4
Set this object to yes( 2 ) to clean up memory of parameters unused by this version.
Status: current
Access: read-write
OBJECT-TYPE
INTEGER
writeOnly(1), yes(2)
systemToolCAMode
1.3.6.1.4.1.1429.2.2.5.8.1.5
Custom Tuning Mode: Conditional Access Mode: Standard/ Open.
Status: current
Access: read-write
OBJECT-TYPE
INTEGER
standard(1), open(2)
systemToolClearLogs
1.3.6.1.4.1.1429.2.2.5.8.1.6
Set this object to yes( 2 ) to clean up memory of logs.
Status: current
Access: read-write
OBJECT-TYPE
INTEGER
writeOnly(1), yes(2)