Unisphere-Data-BRIDGE-ETHERNET-MIB

File: Unisphere-Data-BRIDGE-ETHERNET-MIB.mib (10378 bytes)

Imported modules

SNMPv2-SMI SNMPv2-TC SNMPv2-CONF
IF-MIB Unisphere-Data-MIBs Unisphere-Data-TC

Imported symbols

MODULE-IDENTITY OBJECT-TYPE RowStatus
MODULE-COMPLIANCE OBJECT-GROUP InterfaceIndex
InterfaceIndexOrZero usDataMibs UsdNextIfIndex

Defined Types

UsdBridgedEthernetIfEntry  
SEQUENCE    
  usdBridgedEthernetIfIfIndex InterfaceIndex
  usdBridgedEthernetProxyArp INTEGER
  usdBridgedEthernetIfLowerIfIndex InterfaceIndexOrZero
  usdBridgedEthernetIfRowStatus RowStatus

Defined Values

usdBridgeEthernetMIB 1.3.6.1.4.1.4874.2.2.31
The Bridge Ethernet MIB for the Unisphere Networks Inc. enterprise.
MODULE-IDENTITY    

usdBridgedEthernetObjects 1.3.6.1.4.1.4874.2.2.31.1
OBJECT IDENTIFIER    

usdBridgedEthernetIfLayer 1.3.6.1.4.1.4874.2.2.31.1.1
OBJECT IDENTIFIER    

usdBridgedEthernetNextIfIndex 1.3.6.1.4.1.4874.2.2.31.1.1.1
Coordinate ifIndex value allocation for entries in usdBridgedEthernetIfTable. A GET of this object returns the next available ifIndex value to be used to create an entry in the associated interface table; or zero, if no valid ifIndex value is available. This object also returns a value of zero when it is the lexicographic successor of a varbind presented in an SNMP GETNEXT or GETBULK request, for which circumstance it is assumed that ifIndex allocation is unintended. Successive GETs will typically return different values, thus avoiding collisions among cooperating management clients seeking to create table entries simultaneously.
Status: current Access: read-only
OBJECT-TYPE    
  UsdNextIfIndex  

usdBridgedEthernetIfTable 1.3.6.1.4.1.4874.2.2.31.1.1.2
The parameters for the BridgedEthernet service on this interface.
Status: current Access: not-accessible
OBJECT-TYPE    
  SEQUENCE OF  
    UsdBridgedEthernetIfEntry

usdBridgedEthernetIfEntry 1.3.6.1.4.1.4874.2.2.31.1.1.2.1
The Parameters for a particular Bridged Ethernet interface. Creating/deleting entries in this table causes corresponding entries for be created/deleted in ifTable/ifXTable/usdIfTable
Status: current Access: not-accessible
OBJECT-TYPE    
  UsdBridgedEthernetIfEntry  

usdBridgedEthernetIfIfIndex 1.3.6.1.4.1.4874.2.2.31.1.1.2.1.1
The ifIndex value of the corresponding ifEntry.
Status: current Access: read-only
OBJECT-TYPE    
  InterfaceIndex  

usdBridgedEthernetProxyArp 1.3.6.1.4.1.4874.2.2.31.1.1.2.1.2
The proxyArp configuration setting for this entry. *** NOTE: This MIB object has been obsoleted. ***
Status: obsolete Access: read-create
OBJECT-TYPE    
  INTEGER enableRestricted(1), enableUnrestricted(2), disable(3)  

usdBridgedEthernetIfLowerIfIndex 1.3.6.1.4.1.4874.2.2.31.1.1.2.1.3
The ifIndex of an interface over which this Bridged Ethernet interface is to be layered. A value of zero indicates no layering. An implementation may choose to require that a nonzero value be configured at entry creation.
Status: current Access: read-create
OBJECT-TYPE    
  InterfaceIndexOrZero  

usdBridgedEthernetIfRowStatus 1.3.6.1.4.1.4874.2.2.31.1.1.2.1.4
Controls creation/deletion of entries in this table according to the RowStatus textual convention, constrained to support the following values only: createAndGo destroy To create an entry in this table, the following entry objects MUST be explicitly configured: usdBridgedEthernetIfRowStatus usdBridgedEthernetIfLowerIfIndex In addition, when creating an entry the following conditions must hold: A value for usdBridgedEthernetIfIndex must have been determined previously, by reading usdBridgedEthernetNextIfIndex. The interface identified by usdBridgedEthernetIfLowerIfIndex must exist, and must be an interface type that permits layering of Bridged Ethernet above it. A corresponding entry in ifTable/ifXTable/usdIfTable is created/destroyed as a result of creating/destroying an entry in this table.
Status: current Access: read-create
OBJECT-TYPE    
  RowStatus  

usdBridgeEthernetConformance 1.3.6.1.4.1.4874.2.2.31.4
OBJECT IDENTIFIER    

usdBridgeEthernetCompliances 1.3.6.1.4.1.4874.2.2.31.4.1
OBJECT IDENTIFIER    

usdBridgeEthernetGroups 1.3.6.1.4.1.4874.2.2.31.4.2
OBJECT IDENTIFIER    

usdBridgedEthernetCompliance 1.3.6.1.4.1.4874.2.2.31.4.1.1
The compliance statement for entities which implement the Unisphere bridged Ethernet MIB.
Status: current Access: read-create
MODULE-COMPLIANCE    

usdBridgedEthernetGroup 1.3.6.1.4.1.4874.2.2.31.4.2.1
A collection of objects providing management of Bridged Ethernet interfaces in a Unisphere product. This group became obsolete when usdBridgedEthernetProxyArp was made obsolete.
Status: obsolete Access: read-create
OBJECT-GROUP    

usdBridgedEthernetGroup2 1.3.6.1.4.1.4874.2.2.31.4.2.2
A collection of objects providing management of Bridged Ethernet interfaces in a Unisphere product.
Status: current Access: read-create
OBJECT-GROUP