USR-TRAP-MIB
File:
USR-TRAP-MIB.mib (30777 bytes)
Imported modules
Imported symbols
Defined Values
usr |
1.3.6.1.4.1.429 |
OBJECT IDENTIFIER |
|
|
|
psuWarning |
3 |
Power supply voltage out of normal operating range. |
TRAP-TYPE |
|
|
|
tempWarning |
5 |
Internal hub temperature out of normal operating range. |
TRAP-TYPE |
|
|
|
entityMgtBusFailure |
8 |
Management bus failure. Entity fails to respond to
Managment Card. |
TRAP-TYPE |
|
|
|
connectTimerExpired |
14 |
Modem's connection time limit expired. The connection was
terminated. |
TRAP-TYPE |
|
|
|
dteTransmitDataIdle |
15 |
The DTE connected to this modem has not transmitted
anything to this modem for a period longer than its idle
time threshold. |
TRAP-TYPE |
|
|
|
dtrTrue |
16 |
The attached DTE is asserting the DTR signal in a 'true'
condition. |
TRAP-TYPE |
|
|
|
dtrFalse |
17 |
The DTE attached to this modem is asserting DTR in a
'false' condition. |
TRAP-TYPE |
|
|
|
blerCountAtThreshold |
18 |
This modem's block error counter has exceeded the defined
'good' threshold during the current call. |
TRAP-TYPE |
|
|
|
fallbackCountAtThreshold |
19 |
This modem's fallback counter has exceeded the normal
'good' threshold during the current call. |
TRAP-TYPE |
|
|
|
noDialtone |
20 |
The modem has detected a lack of dial tone when it went off
hook to dial. |
TRAP-TYPE |
|
|
|
noLoopCurrent |
21 |
The modem has detected a lack of loop current on the phone
line when it went off hook to dial. |
TRAP-TYPE |
|
|
|
yellowAlarm |
22 |
A yellow alarm condition exists when the remote end of a
DS1 is experiencing an 'out-of-frame' or 'OOF' condition. |
TRAP-TYPE |
|
|
|
redAlarm |
23 |
The framing pattern has been lost on the DS1's receiver.
This is also known as an 'out-of-frame' or 'OOF' condition. |
TRAP-TYPE |
|
|
|
lossOfSignal |
24 |
The DS1 receiver has received 175 consecutive 0's. The DS1
is unable to recover a receive signal. |
TRAP-TYPE |
|
|
|
alarmIndicationSignal |
25 |
The DS1 is receiving an all ones pattern. This is an
indication that the remote end has lost its receive signal.
This condition is also known as blue alarm. |
TRAP-TYPE |
|
|
|
modemResetByDte |
27 |
This specific trap is generated when modem is reset by
dte. |
TRAP-TYPE |
|
|
|
modemRingNoAnswer |
28 |
If the DTR is present and s0 register on the NAC is not
equal to zero, then the Modem Ring No Answer event is
generated. |
TRAP-TYPE |
|
|
|
dteRingNoAnswer |
29 |
The DTE Ring No Answer event is generated when the DTR is
not present and the s0 register on the NAC is not equal to
zero. |
TRAP-TYPE |
|
|
|
gwWanPortLinkActive |
36 |
A gateway WAN port has changed from Out of Service to Link
Active. |
TRAP-TYPE |
|
|
|
dialOutRestrictedNum |
39 |
A dial out security session has failed as a result of
attempting to dial a restricted phone number. |
TRAP-TYPE |
|
|
|
dialBackRestrictedNum |
40 |
A dial back security session has failed as a result of
attempting to dial a restricted phone number. |
TRAP-TYPE |
|
|
|
userBlacklisted |
41 |
A security user has reached their final failed login
attempt number and is now being blacklisted. |
TRAP-TYPE |
|
|
|
responseAttemptLimExceeded |
43 |
A security user has failed to issue a valid response to a
particular security prompt before the configured limit. |
TRAP-TYPE |
|
|
|
mdmLoginAttemptLimExceeded |
44 |
This signals a security session failure when the indicated
user does not appear in the security user database. |
TRAP-TYPE |
|
|
|
acctSrvrLoss |
49 |
Contact lost with RADIUS accounting server. |
TRAP-TYPE |
|
|
|
redAlarmClear |
51 |
The red alarm condition has been cleared. |
TRAP-TYPE |
|
|
|
contCrcAlarm |
59 |
A continuous CRC error condition has occurred on the DS1. |
TRAP-TYPE |
|
|
|
contCrcAlarmClear |
60 |
A continuous CRC error condition has cleared on the DS1. |
TRAP-TYPE |
|
|
|
phyStateChng |
61 |
A physical state change has occurred on the DS1. |
TRAP-TYPE |
|
|
|