NTNTECH-NMS-TRAPS-V1-MIB
File:
NTNTECH-NMS-TRAPS-V1-MIB.mib (3390 bytes)
Imported modules
Imported symbols
Defined Values
envFanTrap-v1 |
1001 |
There has been a change in the Fan state. |
TRAP-TYPE |
|
|
|
envTempNormal-v1 |
1002 |
The normal operating temperature inside the chassis has returned.
Note: This trap applies to the micro DSLAMs only. |
TRAP-TYPE |
|
|
|
envTempExceeded-v1 |
1003 |
The normal operating temperature inside the chassis has been exceeded.
Note: This trap applies to the micro DSLAMs only. |
TRAP-TYPE |
|
|
|
invIfModPresentTrap-v1 |
2001 |
A change was detected related to the population state of a chassis slot. This
trap will be triggered when the population state of a slot makes the transition
from vacant to present, where present is any valid interface module type as
defined by 'ifStaType'. |
TRAP-TYPE |
|
|
|
invIfModRemovedTrap-v1 |
2002 |
A change was detected related to the population state of a chassis slot. This
trap will be triggered when the population state of a slot makes the transition
from present, to vacant. In otherwords, this trap will be triggered if an interface
module of type 'a' is immediately replaced with one of type 'b' or 40 seconds after
an interface module is removed leaving the slot vacant. |
TRAP-TYPE |
|
|
|