Juniper-IPV6-PROFILE-MIB

File: Juniper-IPV6-PROFILE-MIB.mib (17220 bytes)

Imported modules

SNMPv2-SMI SNMPv2-TC SNMPv2-CONF
INET-ADDRESS-MIB IPV6-TC Juniper-MIBs
Juniper-TC

Imported symbols

MODULE-IDENTITY OBJECT-TYPE Integer32
Unsigned32 DisplayString MODULE-COMPLIANCE
OBJECT-GROUP InetAddressIPv6 Ipv6AddressPrefix
juniMibs JuniEnable JuniName
JuniSetMap

Defined Types

JuniIpv6ProfileEntry  
SEQUENCE    
  juniIpv6ProfileId Unsigned32
  juniIpv6ProfileSetMap JuniSetMap
  juniIpv6ProfileRouterName JuniName
  juniIpv6ProfileIpv6Addr InetAddressIPv6
  juniIpv6ProfileIpv6MaskLen Integer32
  juniIpv6ProfileMtu Integer32
  juniIpv6ProfileSrcAddrValidEnable JuniEnable
  juniIpv6ProfileInheritNumString DisplayString
  juniIpv6ProfileNdEnabled JuniEnable
  juniIpv6ProfileNdManagedConfig JuniEnable
  juniIpv6ProfileNdOtherConfig JuniEnable
  juniIpv6ProfileNdSuppressRa JuniEnable
  juniIpv6ProfileNdRaInterval Integer32
  juniIpv6ProfileNdRaLifeTime Integer32
  juniIpv6ProfileNdReachableTime Integer32
  juniIpv6ProfileNdPrefix Ipv6AddressPrefix
  juniIpv6ProfileNdPrefixLength Integer32
  juniIpv6ProfileNdPrefixOnLinkFlag JuniEnable
  juniIpv6ProfileNdPrefixAutonomousFlag JuniEnable
  juniIpv6ProfileNdPrefixPreferredLifetime Integer32
  juniIpv6ProfileNdPrefixValidLifetime Integer32

Defined Values

juniIpv6ProfileMIB 1.3.6.1.4.1.4874.2.2.68
The IPv6 Profile MIB for the Juniper Networks enterprise.
MODULE-IDENTITY    

juniIpv6ProfileObjects 1.3.6.1.4.1.4874.2.2.68.1
OBJECT IDENTIFIER    

juniIpv6Profile 1.3.6.1.4.1.4874.2.2.68.1.1
OBJECT IDENTIFIER    

juniIpv6ProfileTable 1.3.6.1.4.1.4874.2.2.68.1.1.1
The entries in this table describe profiles for configuring IP interfaces. Entries in this table are created/deleted as a side-effect of corresponding operations to the juniProfileNameTable in the Juniper-PROFILE-MIB.
Status: current Access: not-accessible
OBJECT-TYPE    
  SEQUENCE OF  
    JuniIpv6ProfileEntry

juniIpv6ProfileEntry 1.3.6.1.4.1.4874.2.2.68.1.1.1.1
A profile describing configuration of an IPv6 interface.
Status: current Access: not-accessible
OBJECT-TYPE    
  JuniIpv6ProfileEntry  

juniIpv6ProfileId 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.1
The integer identifier associated with this profile. A value for this identifier is determined by locating or creating a profile name in the juniProfileNameTable.
Status: current Access: not-accessible
OBJECT-TYPE    
  Unsigned32  

juniIpv6ProfileSetMap 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.2
A bitmap representing which objects in this entry have been explicitly configured. See the definition of the JuniSetMap TEXTUAL-CONVENTION for details of use. The INDEX object(s) and this object are excluded from representation (i.e. their bits are never set). When a SET request does not explicitly configure JuniSetMap, bits in JuniSetMap are set as a side-effect of configuring other profile attributes in the same entry. If, however, a SET request explicitly configures JuniSetMap, the explicitly configured value overrides 1) any previous bit settings, and 2) any simultaneous 'side-effect' settings that would otherwise occur. Once set, bits can only be cleared by explicitly configuring JuniSetMap.
Status: current Access: read-write
OBJECT-TYPE    
  JuniSetMap  

juniIpv6ProfileRouterName 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.3
The virtual router to which an IPv6 interface configured by this profile will be assigned, if other mechanisms do not otherwise specify a virtual router assignment.
Status: current Access: read-write
OBJECT-TYPE    
  JuniName  

juniIpv6ProfileIpv6Addr 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.4
An IPv6 address to be used by an IPv6 interface configured by this profile. This object will have a value of 0::0 for an unnumbered interface.
Status: current Access: read-write
OBJECT-TYPE    
  InetAddressIPv6  

juniIpv6ProfileIpv6MaskLen 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.5
An IPv6 address mask length to be used by an IPv6 interface configured by this profile. This object will have a value of 0 for an unnumbered interface.
Status: current Access: read-write
OBJECT-TYPE    
  Integer32 0..128  

juniIpv6ProfileMtu 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.6
The configured MTU size for this IPv6 network interface. If set to zero, the default MTU size, as determined by the underlying network media, is used.
Status: current Access: read-write
OBJECT-TYPE    
  Integer32 0 | 1280..10240  

juniIpv6ProfileSrcAddrValidEnable 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.7
Enable/disable whether source addresses in received IPv6 packets are validated. Validation is performed by looking up the source IPv6 address in the routing database and determining whether the packet arrived on the expected interface; if not, the packet is discarded.
Status: current Access: read-write
OBJECT-TYPE    
  JuniEnable  

juniIpv6ProfileInheritNumString 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.8
The text identifier of the numbered interface, associated with the specified virtual router, whose IPv6 address is used as the source address when transmitting IPv6 packets on unnumbered remote access user links. Types/formats/examples for this string include: Loopback loopback 'loopback 0' ATM Virtual Circuit atm /. 'atm 3/1.100' Ethernet { fastEthernet | gigabitEthernet } / 'fastEthernet 3/0' 'gigabitEthernet 3/0' Ethernet VLAN { fastEthernet | gigabitEthernet } /: 'fastEthernet 3/0:1000' 'gigabitEthernet 3/0:1000' Channelized Serial serial /:[/]* 'serial 3/0:4' (T1/E1) 'serial 3/0:2/4' (T3/E3) 'serial 3/0:2/1/1/4' (OC3/OC12 - channelized DS3) 'serial 3/0:2/1/1/1/4' (OC3/OC12 - virtual tributaries) Other formats may be supported over time. An empty string indicates the referenced interface is unspecified, e.g., when this IPv6 interface is numbered.
Status: current Access: read-write
OBJECT-TYPE    
  DisplayString Size(0..80)  

juniIpv6ProfileNdEnabled 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.9
Enable/disable ND for this IPv6 network interface.
Status: current Access: read-write
OBJECT-TYPE    
  JuniEnable  

juniIpv6ProfileNdManagedConfig 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.10
Enable/disable ND managed config for this IPv6 network interface.
Status: current Access: read-write
OBJECT-TYPE    
  JuniEnable  

juniIpv6ProfileNdOtherConfig 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.11
Enable/disable ND other config for this IPv6 network interface.
Status: current Access: read-write
OBJECT-TYPE    
  JuniEnable  

juniIpv6ProfileNdSuppressRa 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.12
Enable/disable ND suppress RA for this IPv6 network interface.
Status: current Access: read-write
OBJECT-TYPE    
  JuniEnable  

juniIpv6ProfileNdRaInterval 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.13
The configured interval between IPv6 RA transmissions on the interface.
Status: current Access: read-write
OBJECT-TYPE    
  Integer32 3..1800  

juniIpv6ProfileNdRaLifeTime 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.14
The configured RA lifetime for this IPv6 network interface.
Status: current Access: read-write
OBJECT-TYPE    
  Integer32 0..1800  

juniIpv6ProfileNdReachableTime 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.15
The configured RA reachable time for this IPv6 network interface.
Status: current Access: read-write
OBJECT-TYPE    
  Integer32  

juniIpv6ProfileNdPrefix 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.16
The prefix associated with the this interface.
Status: current Access: read-write
OBJECT-TYPE    
  Ipv6AddressPrefix  

juniIpv6ProfileNdPrefixLength 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.17
The length of the prefix (in bits).
Status: current Access: read-write
OBJECT-TYPE    
  Integer32 1..128  

juniIpv6ProfileNdPrefixOnLinkFlag 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.18
This object has the value 'true(1)', if this prefix can be used for on-link determination and the value 'false(2)' otherwise.
Status: current Access: read-write
OBJECT-TYPE    
  JuniEnable  

juniIpv6ProfileNdPrefixAutonomousFlag 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.19
Autonomous address configuration flag. When true(1), indicates that this prefix can be used for autonomous address configuration (i.e. can be used to form a local interface address). If false(2), it is not used to autoconfigure a local interface address.
Status: current Access: read-write
OBJECT-TYPE    
  JuniEnable  

juniIpv6ProfileNdPrefixPreferredLifetime 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.20
It is the length of time in seconds that this prefix will remain preferred, i.e. time until deprecation. A value of 4,294,967,295 represents infinity. The address generated from a deprecated prefix should no longer be used as a source address in new communications, but packets received on such an interface are processed as expected.
Status: current Access: read-write
OBJECT-TYPE    
  Integer32  

juniIpv6ProfileNdPrefixValidLifetime 1.3.6.1.4.1.4874.2.2.68.1.1.1.1.21
It is the length of time in seconds that this prefix will remain valid, i.e. time until invalidation. A value of 4,294,967,295 represents infinity. The address generated from an invalidated prefix should not appear as the destination or source address of a packet.
Status: current Access: read-write
OBJECT-TYPE    
  Integer32  

juniIpv6ProfileMIBConformance 1.3.6.1.4.1.4874.2.2.68.4
OBJECT IDENTIFIER    

juniIpv6ProfileMIBCompliances 1.3.6.1.4.1.4874.2.2.68.4.1
OBJECT IDENTIFIER    

juniIpv6ProfileMIBGroups 1.3.6.1.4.1.4874.2.2.68.4.2
OBJECT IDENTIFIER    

juniIpv6ProfileCompliance 1.3.6.1.4.1.4874.2.2.68.4.1.1
Obsolete Compliance statement for systems supporting IPv6 configuration profiles. This statement became obsolete when added ND support.
Status: obsolete Access: read-write
MODULE-COMPLIANCE    

juniIpv6ProfileCompliance1 1.3.6.1.4.1.4874.2.2.68.4.1.2
Compliance statement for systems supporting IPv6 configuration profiles, incorporating support of ND on dynamical interface.
Status: current Access: read-write
MODULE-COMPLIANCE    

juniIpv6ProfileGroup 1.3.6.1.4.1.4874.2.2.68.4.2.1
An obsolete collection of objects providing management of IPv6 Profile functionality in a Juniper product. This statement became obsolete when added ND support.
Status: obsolete Access: read-write
OBJECT-GROUP    

juniIpv6ProfileGroup1 1.3.6.1.4.1.4874.2.2.68.4.2.2
The basic collection of objects providing management of IPv6 Profile functionality in a Juniper product.
Status: current Access: read-write
OBJECT-GROUP