Juniper-Experiment

File: Juniper-Experiment.mib (4356 bytes)

Imported modules

SNMPv2-SMI Juniper-UNI-SMI

Imported symbols

MODULE-IDENTITY OBJECT-IDENTITY juniperUniExperiment

Defined Values

juniExperiment 1.3.6.1.4.1.4874.3.2
The object identifiers for experimental MIBs for the Juniper Networks, Inc. edge router products. This is the top-level object identifier registry for SNMP modules containing experimental MIB definitions. Experimental MIBs are defined as: 1) IETF work-in-process MIBs which have not been assigned a permanent object identifier by the IANA. 2) Juniper work-in-process MIBs that have not achieved final production quality or field experience. NOTE: Support for MIBs under the this OID subtree is temporary and changes to objects may occur without notice.
MODULE-IDENTITY    

juniDvmrpExperiment 1.3.6.1.4.1.4874.3.2.1
The object identifier used to anchor the experimental IETF draft for the Distance Vector Multicast Routing Protocol (DVMRP) MIB.
Status: current Access: read-only
OBJECT-IDENTITY    

juniSonetApsExperiment 1.3.6.1.4.1.4874.3.2.2
The object identifier used to anchor the experimental IETF draft for the SONET linear Automatic Protection Switching (APS) MIB.
Status: current Access: read-only
OBJECT-IDENTITY    

juniMplsExperiment 1.3.6.1.4.1.4874.3.2.3
The object identifier used to anchor the experimental IETF drafts for the Multiprotocol Label Switching (MPLS) set of MIBs.
Status: current Access: read-only
OBJECT-IDENTITY    

juniMplsVPNExperiment 1.3.6.1.4.1.4874.3.2.4
The object identifier used to anchor the experimental IETF drafts for the MPLS/BGP Layer 3 Virtual Private Network Management Information Base.
Status: current Access: read-only
OBJECT-IDENTITY    

juniBFDExperiment 1.3.6.1.4.1.4874.3.2.5
The object identifier used to anchor the experimental IETF drafts for BFD Management Information Base.
Status: current Access: read-only
OBJECT-IDENTITY