HPN-ICF-DOT11-WLANEXT-MIB
File:
HPN-ICF-DOT11-WLANEXT-MIB.mib (11291 bytes)
Imported modules
Imported symbols
Defined Types
| HpnicfDot11RFSignalStatisEntry |
|
| SEQUENCE |
|
|
|
| |
hpnicfDot11RFAPID |
HpnicfDot11ObjectIDType |
|
| |
hpnicfDot11RFRadioID |
HpnicfDot11RadioScopeType |
|
| |
hpnicfDot11RFSignalStatisInterv |
Integer32 |
|
| |
hpnicfDot11RFAverageSignalStrength |
Integer32 |
|
| |
hpnicfDot11RFMaxSignalStrength |
Integer32 |
|
| |
hpnicfDot11RFMinSignalStrength |
Integer32 |
|
| HpnicfDot11QosStatisEntry |
|
| SEQUENCE |
|
|
|
| |
hpnicfDot11QosAPID |
HpnicfDot11ObjectIDType |
|
| |
hpnicfDot11QosRadioID |
HpnicfDot11RadioScopeType |
|
| |
hpnicfDot11QosAverageQueLen |
Integer32 |
|
| |
hpnicfDot11QosDropFrameRatio |
Integer32 |
|
| |
hpnicfDot11QosAverageDataRate |
Integer32 |
|
| HpnicfDot11QosAcStatisEntry |
|
| SEQUENCE |
|
|
|
| |
hpnicfDot11QosAcType |
HpnicfDot11QosAcType |
|
| |
hpnicfDot11AcDropFrameCnt |
Counter32 |
|
Defined Values
| hpnicfDot11WLANEXT |
1.3.6.1.4.1.11.2.14.11.15.2.75.7 |
| This MIB provides more information for WLAN network.
GLOSSARY
IEEE 802.11
Standard to encourage interoperability among
wireless networking equipment.
IEEE 802.11e
Standard to define the MAC procedures to support
LAN applications with Quality of Service (QoS) requirements,
including the transport of voice, audio and video over
IEEE 802.11 wireless LANs.
Access point (AP)
Transmitter/receiver (transceiver) device
that commonly connects and transports data
between a wireless network and a wired network.
Access control (AC)
To control and manage multi-APs, it will bridge
wireless and wired network.
Radio
The chip set to receive and send wireless signal.
Fat AP
Applied in the home, SOHO and so on, and it could
independently work without help from AC.
Fit AP
Applied in the enterprise environment, it will work
under the control and management from AC.
Control And Provisioning of Wireless Access Points Protocol
The short name of protocol is CAPWAP. AC will control
and manage AP by CAPWAP tunnel protocol defined by IETF.
Also, a data tunnel will be set up between AC and AP.
Basic Service Set
The IEEE 802.11 BSS of an AP comprises of the
stations directly associating with the AP. It will
be identified by BSSID. |
| MODULE-IDENTITY |
|
|
|
| hpnicfDot11RFSignalStatisEntry |
1.3.6.1.4.1.11.2.14.11.15.2.75.7.1.1.1 |
| Each entry contains the signal of each signal strength information of
a specific AP. |
| Status: current |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
HpnicfDot11RFSignalStatisEntry |
|
|
| hpnicfDot11RFMaxSignalStrength |
1.3.6.1.4.1.11.2.14.11.15.2.75.7.1.1.1.5 |
| Represents the maximum value of signal strength
for stations on a specific radio. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
Integer32 |
|
|
| hpnicfDot11RFMinSignalStrength |
1.3.6.1.4.1.11.2.14.11.15.2.75.7.1.1.1.6 |
| Represents the minimum value of signal strength
for stations on a specific radio. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
Integer32 |
|
|
| hpnicfDot11QosStatisEntry |
1.3.6.1.4.1.11.2.14.11.15.2.75.7.2.1.1 |
| Each entry contains information of the Qos attribute of each radio. |
| Status: current |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
HpnicfDot11QosStatisEntry |
|
|
| hpnicfDot11QosDropFrameRatio |
1.3.6.1.4.1.11.2.14.11.15.2.75.7.2.1.1.4 |
| The ratio of dropped frames in a minute because of full queue. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
Integer32 |
|
|
| hpnicfDot11QosAcStatisEntry |
1.3.6.1.4.1.11.2.14.11.15.2.75.7.2.2.1 |
| Each entry contains information of each Qos access category. |
| Status: current |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
HpnicfDot11QosAcStatisEntry |
|
|
| hpnicfDot11AcDropFrameCnt |
1.3.6.1.4.1.11.2.14.11.15.2.75.7.2.2.1.2 |
| The number of dropped frames in a minute for one specific access
category because of full queue. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
Counter32 |
|
|