HP-SN-MPLS-TC-MIB

File: HP-SN-MPLS-TC-MIB.mib (9236 bytes)

Imported modules

SNMPv2-SMI RFC1213-MIB SNMPv2-TC
FOUNDRY-SN-ROOT-MIB

Imported symbols

MODULE-IDENTITY Unsigned32 Integer32
transmission TEXTUAL-CONVENTION snMpls

Defined Types

MplsAtmVcIdentifier  
The VCI value for a VCL. The maximum VCI value cannot exceed the value allowable by atmInterfaceMaxVciBits defined in ATM-MIB. The minimum value is 32, values 0 to 31 are reserved for other uses by the ITU and ATM Forum. 32 is typically the default value for the Control VC.
TEXTUAL-CONVENTION    
  Integer32 32..65535  

MplsBitRate  
An estimate of bandwidth in units of 1,000 bits per second. If this object reports a value of 'n' then the rate of the object is somewhere in the range of 'n-500' to 'n+499'. For objects which do not vary in bit rate, or for those where no accurate estimation can be made, this object should contain the nominal bit rate.
TEXTUAL-CONVENTION    
  Integer32 1..2147483647  

MplsBurstSize  
The number of octets of MPLS data that the stream may send back-to-back without concern for policing.
TEXTUAL-CONVENTION    
  Unsigned32 1..4294967295  

MplsExtendedTunnelId  
A unique identifier for an MPLS Tunnel. This MAY represent an IpV4 address of the ingress or egress LSR for the tunnel. This value is derived from the Extended Tunnel Id in RSVP or the Ingress Router ID for CR-LDP.
TEXTUAL-CONVENTION    
  Unsigned32  

MplsInitialCreationSource  
The entity that originally created the object in question. The values of this enumeration are defined as follows: other(1) - This is used when an entity which has not been enumerated in this textual convention but which is known by the agent. snmp(2) - The Simple Network Management Protocol was used to configure this object initially. ldp(3 - The Label Distribution Protocol was used to configure this object initially. rsvp(4) - The Resource Reservation Protocol was used to configure this object initially. crldp(5) - The Constraint-Based Label Distribution Protocol was used to configure this object initially. policyAgent(6) - A policy agent (perhaps in combination with one of the above protocols) was used to configure this object initially. unknown(7) - the agent cannot discern which component created the object.
TEXTUAL-CONVENTION    
  INTEGER other(1), snmp(2), ldp(3), rsvp(4), crldp(5), policyAgent(6), unknown(7)  

MplsLSPID  
An identifier that is assigned to each LSP and is used to uniquely identify it. This is assigned at the head end of the LSP and can be used by all LSRs to identify this LSP. This value is piggybacked by the signaling protocol when this LSP is signaled within the network. This identifier can then be used at each LSR to identify which labels are being swapped to other labels for this LSP. For IPv4 addresses this results in a 6-octet long cookie.
TEXTUAL-CONVENTION    
  OCTET STRING Size(0..31)  

MplsLabel  
This value represents an MPLS label as defined in [RFC3031], [RFC3032], [RFC3034] and [RFC3035].
TEXTUAL-CONVENTION    
  Unsigned32 0..4294967295  

MplsLdpGenAddr  
The value of an network layer or data link layer address.
TEXTUAL-CONVENTION    
  OCTET STRING Size(0..64)  

MplsLdpIdentifier  
The LDP identifier is a six octet quantity which is used to identify an Label Switch Router (LSR) label space. The first four octets identify the LSR and must be a globally unique value, such as a 32-bit router ID assigned to the LSR, and the last two octets identify a specific label space within the LSR.
TEXTUAL-CONVENTION    
  OCTET STRING Size(6)  

MplsLdpLabelTypes  
The Layer 2 label types which are defined for MPLS LDP/CRLDP are generic(1), atm(2), or frameRelay(3).
TEXTUAL-CONVENTION    
  INTEGER generic(1), atm(2), frameRelay(3)  

MplsLsrIdentifier  
The Label Switch Router (LSR) identifier is the first 4 bytes of the Label Distribution Protocol (LDP) identifier.
TEXTUAL-CONVENTION    
  OCTET STRING Size(4)  

MplsPathIndex  
A unique identifier used to identify a specific path used by a tunnel.
TEXTUAL-CONVENTION    
  Unsigned32  

MplsPathIndexOrZero  
A unique identifier used to identify a specific path used by a tunnel. If this value is set to 0, it indicates that no path is in use.
TEXTUAL-CONVENTION    
  Unsigned32  

MplsPortNumber  
A TCP or UDP port number. Along with an IP address identifies a stream of IP traffic uniquely.
TEXTUAL-CONVENTION    
  Integer32 0..65535  

MplsTunnelAffinity  
Include-any, include-all, or exclude-all constraint for link selection.
TEXTUAL-CONVENTION    
  Unsigned32  

MplsTunnelIndex  
Index into mplsTunnelTable.
TEXTUAL-CONVENTION    
  Integer32 1..65535  

MplsTunnelInstanceIndex  
Instance index into mplsTunnelTable.
TEXTUAL-CONVENTION    
  Unsigned32 0..65535  

Defined Values

mplsTCMIB 1.3.6.1.4.1.1991.1.2.15.15.1
This MIB module defines Textual Conventions and OBJECT-IDENTITIES for use in documents defining management information bases (MIBs) for managing MPLS networks.
MODULE-IDENTITY    

mplsMIB 1.3.6.1.4.1.1991.1.2.15.15
OBJECT IDENTIFIER