EXTREME-SNMPV3-MIB

File: EXTREME-SNMPV3-MIB.mib (7811 bytes)

Imported modules

SNMPv2-SMI	SNMPv2-TC	EXTREME-BASE-MIB
SNMP-TARGET-MIB

Imported symbols

MODULE-IDENTITY	Integer32	OBJECT-TYPE
DisplayString	IpAddress	TruthValue
extremeAgent	snmpTargetAddrEntry

Defined Types

ExtremeTargetAddrExtEntry
SEQUENCE
	extremeTargetAddrExtIgnoreMPModel	TruthValue
	extremeTargetAddrExtStandardMode	TruthValue
	extremeTargetAddrExtTrapDestIndex	Integer32
	extremeTargetAddrExtUseEventComm	TruthValue
	extremeTargetAddrExtTrapSrcIp	IpAddress
	extremeTargetAddrExtVrName	DisplayString

Defined Values

extremeSnmpv3		1.3.6.1.4.1.1916.1.23
Extreme-specific SNMPv3 objects
MODULE-IDENTITY

extremeTarget		1.3.6.1.4.1.1916.1.23.1
OBJECT IDENTIFIER

extremeUsm		1.3.6.1.4.1.1916.1.23.2
OBJECT IDENTIFIER

extremeTargetAddrExtTable		1.3.6.1.4.1.1916.1.23.1.1
This table is an extension to the snmpTargetAddrTable found in the SNMP-TARGET-MIB. It contains Extreme Networks specific objects needed for each management target.
Status: current	Access: not-accessible
OBJECT-TYPE
	SEQUENCE OF
		ExtremeTargetAddrExtEntry

extremeTargetAddrExtEntry		1.3.6.1.4.1.1916.1.23.1.1.1
An entry in the extremeTargetAddrExtTable.
Status: current	Access: not-accessible
OBJECT-TYPE
	ExtremeTargetAddrExtEntry

extremeTargetAddrExtIgnoreMPModel		1.3.6.1.4.1.1916.1.23.1.1.1.1
When this object is set to TRUE, the version of the trap/notification sent to the corresponding management target (trap receiver) will be the same as in releases of Extremeware prior to 7.1.0. Thus, the value of the snmpTargetParamsMPModel object in the snmpTargetParamsTable will be ignored while determining the version of the trap/notification to be sent. When a trap-receiver is created via the RMON trapDestTable or from the CLI command 'configure snmp add trapreceiver ....', the value of this object will be set to TRUE for the corresponding entry in this table.
Status: current	Access: read-write
OBJECT-TYPE
	TruthValue

extremeTargetAddrExtStandardMode		1.3.6.1.4.1.1916.1.23.1.1.1.2
When this object is set to TRUE, the management target will be treated as a 'standard mode' one, in that any Extreme Networks specific extra varbinds present in a standards-based trap/notification will not be sent to this management target. Only the varbinds defined in the standard will be sent.
Status: current	Access: read-write
OBJECT-TYPE
	TruthValue

extremeTargetAddrExtTrapDestIndex		1.3.6.1.4.1.1916.1.23.1.1.1.3
This object contains the value of the trapDestIndex in the corresponding entry of the RMON trapDestTable.
Status: current	Access: read-only
OBJECT-TYPE
	Integer32

extremeTargetAddrExtUseEventComm		1.3.6.1.4.1.1916.1.23.1.1.1.4
This object is used only when sending RMON alarms as SNMPv3 traps. When it is set to TRUE and an RMON risingAlarm or fallingAlarm is being sent for an event, then the eventCommunity in the RMON event table is compared to the snmpTargetAddrName in the snmpTargetAddrTable. The alarm is sent to the target only when the two are the same. This behavior is exhibited only when the snmpTargetParamsMPModel corresponding to the target indicates an SNMPv3 trap. For SNMPv1/v2c traps, the community in the RMON trapDestTable is used for the comparision, which is the 'regular' method, as per the standards. When this object is set to FALSE, then the RMON alarm (if being sent as an SNMPv3 trap) is sent without using the event community for any comparision.
Status: current	Access: read-write
OBJECT-TYPE
	TruthValue

extremeTargetAddrExtTrapSrcIp		1.3.6.1.4.1.1916.1.23.1.1.1.5
This object contains the source IP address from which traps have to be sent out. If this object is assigned an IP address that does not belong to the switch, an error is thrown.
Status: current	Access: read-write
OBJECT-TYPE
	IpAddress

extremeTargetAddrExtVrName		1.3.6.1.4.1.1916.1.23.1.1.1.6
This object contains the virtual router name through which the SNMP Traps are being sent out. If extremeTargetAddrExtVrName is not specified then the SNMP Traps will be sent out through either VR-Mgmt or VR-Default.
Status: current	Access: read-write
OBJECT-TYPE
	DisplayString	Size(0..32)

extremeUsm3DESPrivProtocol		1.3.6.1.4.1.1916.1.23.2.1
The 3DES-EDE Symmetric Encryption Protocol. This is the protocol as specified in draft-reeder-snmpv3-usm-3desede-00.
Status: current	Access: read-write
OBJECT-IDENTITY

extremeUsmAesCfb192Protocol		1.3.6.1.4.1.1916.1.23.2.2
The CFB128-AES-192 Privacy Protocol.
Status: current	Access: read-write
OBJECT-IDENTITY

extremeUsmAesCfb256Protocol		1.3.6.1.4.1.1916.1.23.2.3
The CFB128-AES-256 Privacy Protocol.
Status: current	Access: read-write
OBJECT-IDENTITY

Generation date: July 28, 2023, 16:18:13, Copyright © 2007 - 2022 - Circitor