CISCO-WAN-RPM-CONN-EXT-MIB
File:
CISCO-WAN-RPM-CONN-EXT-MIB.mib (10917 bytes)
Imported modules
Imported symbols
Defined Types
| CwRpmChanExtEntry |
|
| SEQUENCE |
|
|
|
| |
cwrChanSubInterface |
Unsigned32 |
|
| |
cwrChanVcd |
Unsigned32 |
|
| |
cwrChanAalEncapType |
INTEGER |
|
| |
cwrChanVirtualTemplate |
Unsigned32 |
|
| |
cwrChanInArpInterval |
Unsigned32 |
|
| |
cwrChanOamLoopbkTxInterval |
Unsigned32 |
|
| |
cwrChanOamManage |
TruthValue |
|
| |
cwrChanOamRetryUpCount |
Unsigned32 |
|
| |
cwrChanOamRetryDownCount |
Unsigned32 |
|
| |
cwrChanOamRetryInterval |
Unsigned32 |
|
Defined Values
| ciscoWanRpmConnExtMIB |
1.3.6.1.4.1.351.150.9 |
| This MIB together with the CISCO-WAN-ATM-CONN-MIB support
provisioning of PVC endpoints and SPVCs on the MGX's Route
Processor Module (RPM). |
| MODULE-IDENTITY |
|
|
|
| cwRpmChanExtTable |
1.3.6.1.4.1.351.150.9.1.1.1 |
| This table together with the 'cwAtmChanCnfgTable' support
provisioning of PVC endpoints and SPVCs on an RPM. This
table contains objects that are specific to RPM.
This table is an augmentation to the 'cwAtmChanCnfgTable'. |
| Status: current |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
SEQUENCE OF |
|
|
| |
|
CwRpmChanExtEntry |
|
| cwRpmChanExtEntry |
1.3.6.1.4.1.351.150.9.1.1.1.1 |
| Each entry contains RPM specific parameters for a
connection endpoint on an RPM. |
| Status: current |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
CwRpmChanExtEntry |
|
|
| cwrChanSubInterface |
1.3.6.1.4.1.351.150.9.1.1.1.1.1 |
| The RPM's backplane sub-interface for which this channel
is configured. Sub-interface 0 means the switch port. |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
0..4294967295 |
|
| cwrChanVcd |
1.3.6.1.4.1.351.150.9.1.1.1.1.2 |
| Virtual Circuit Descriptor. A unique number which identifies
a connection. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
0..4095 |
|
| cwrChanAalEncapType |
1.3.6.1.4.1.351.150.9.1.1.1.1.3 |
| ATM adaptation layer (AAL) and Encapsulation type.
aal5ciscoPPP - For Cisco PPP over ATM.
'cwrChanVirtualTemplate' is required to be
set for this type.
aal5muxAPOLLO - For a multiplex (MUX) - type virtual
circuit using the Apollo protocol.
aal5muxAPPLETALK - For a MUX-type virtual circuit using the
AppleTalk protocol.
aal5muxDECNET - For a MUX-type virtual circuit using the
DECnet protocol.
aal5muxIP - For a MUX-type virtual circuit using the
IP protocol.
aal5muxIPX - For a MUX-type virtual circuit using the
IPX protocol.
aal5muxPPP - For a MUX-type virtual circuit using the
PPP protocol.
'cwrChanVirtualTemplate' is required to be
set for this type.
aal5muxVINES - For a MUX-type virtual circuit using the
VINES protocol.
aal5muxXNS - For a MUX-type virtual circuit using the
XNS protocol.
aal5nlpid - Allows ATM interfaces to interoperate with
HSSI.
aal5snap - The only encapsulation supported for
Inverse ARP. Logical Link Control/
Subnetwork Access Protocol (LLC/SNAP)
precedes the protocol datagram.
ilmi - Used to set up communication with ILMI.
qsaal - A signalling type PVC used for setting up
or tearing down SVCs. |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
aal5ciscoPPP(1), aal5muxAPOLLO(2), aal5muxAPPLETALK(3), aal5muxDECNET(4), aal5muxIP(5), aal5muxIPX(6), aal5muxPPP(7), aal5muxVINES(8), aal5muxXNS(9), aal5nlpid(10), aal5snap(11), ilmi(12), qsaal(13) |
|
| cwrChanVirtualTemplate |
1.3.6.1.4.1.351.150.9.1.1.1.1.4 |
| This object identifies the virtual template.
The non-zero value need to be specified for
Cisco PPP or MUX-type PPP encapsulation
(i.e. cwrChanAalEncapType = aal5ciscoPPP or
aal5muxPPP).
The value 0 signifies that Virtual Template
is not applicable. |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
0..200 |
|
| cwrChanInArpInterval |
1.3.6.1.4.1.351.150.9.1.1.1.1.5 |
| This specifies how often Inverse ARP datagrams will be sent
on this channel. 0 will disable the InArp for this channel.
This object is only supported for aal5snap encapsulation
(i.e. cwrChanAalEncapType = aal5snap). |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
0..60 |
|
| cwrChanOamLoopbkTxInterval |
1.3.6.1.4.1.351.150.9.1.1.1.1.6 |
| This specifies how often to generate an OAM F5 loopback cell
from this channel. 0 will disable generation of OAM F5
loopback cells. |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
0..600 |
|
| cwrChanOamManage |
1.3.6.1.4.1.351.150.9.1.1.1.1.7 |
| This enables/disables OAM management for this channel.
If set to true(1), OAM management is enabled. |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
TruthValue |
|
|
| cwrChanOamRetryUpCount |
1.3.6.1.4.1.351.150.9.1.1.1.1.8 |
| Number of consecutive end-to-end F5 OAM loopback cell
responses that must be received in order to change a PVC
connection state to up.
This object only applies if OAM management is enabled
(i.e. cwrChanOAMManage = true). |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
1..600 |
|
| cwrChanOamRetryDownCount |
1.3.6.1.4.1.351.150.9.1.1.1.1.9 |
| Number of consecutive end-to-end F5 OAM loopback cell
responses that are not received in order to change a PVC
connection state to down.
This object only applies if OAM management is enabled
(i.e. cwrChanOAMManage = true). |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
1..600 |
|
| cwrChanOamRetryInterval |
1.3.6.1.4.1.351.150.9.1.1.1.1.10 |
| The frequency that end-to-end F5 OAM loopback cells are
transmitted when a change in UP/DOWN state of a PVC is
being verified.
This object only applies if OAM management is enabled
(i.e. cwrChanOAMManage = true). |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
Unsigned32 |
1..1000 |
|
| ciscoWanRpmConnExtMIBCompliance |
1.3.6.1.4.1.351.150.9.2.1.1 |
| The compliance statement for the Cisco MGX RPM connection
management group. |
| Status: current |
Access: read-create |
| MODULE-COMPLIANCE |
|
|
|
| ciscoWanRpmConnExtMIBGroup |
1.3.6.1.4.1.351.150.9.2.2.1 |
| Objects related to ATM connection in RPM module. |
| Status: current |
Access: read-create |
| OBJECT-GROUP |
|
|
|