CISCO-SYSTEM-MIB
File:
CISCO-SYSTEM-MIB.mib (23717 bytes)
Imported modules
Imported symbols
Defined Values
| ciscoSystemMIB |
1.3.6.1.4.1.9.9.131 |
| The systemGroup (see RFC 1907) provides a standard set of
basic system information. This MIB module contains
Cisco-defined extensions to the systemGroup. |
| MODULE-IDENTITY |
|
|
|
| csyClock |
1.3.6.1.4.1.9.9.131.1.1 |
| OBJECT IDENTIFIER |
|
|
|
| csyGeneral |
1.3.6.1.4.1.9.9.131.1.6 |
| OBJECT IDENTIFIER |
|
|
|
| csyClockDateAndTime |
1.3.6.1.4.1.9.9.131.1.1.1 |
| The current local date and time for the system.
Setting this object is equivalent to setting an automated
clock and calendar. The value of the object will track the
date and time from the value set. Note that due to hardware
limitations some systems may not be able to preserve such
meaning across reboots of the system, as indicated by
csyClockLostOnReboot.
A constant value of all zeros and length 8 indicates the
system is not aware of the present date and time.
This object may be read-only on some systems. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
DateAndTime |
|
|
| csyClockLostOnReboot |
1.3.6.1.4.1.9.9.131.1.1.2 |
| Indication of whether the system can preserve knowledge of
current date and time across a system reboot.
A value of 'true' indicates the clock must be reset from some
external source each time the system reboots.
A value of 'false' indicates the system has the ability to
keep time across reboots. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
TruthValue |
|
|
| csyLocationCountry |
1.3.6.1.4.1.9.9.131.1.2.1 |
| The country where the system is physically located.
On some systems and for some technologies this value affects
behavior, such as standards for communication. All such
technologies should default to using the setting of this
value, but may provide an override if necessary.
The default value of this object is 'US'. Systems destined
for other countries may use a different default. Systems in
which the value does not affect operation should default to
a zero-length value. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
CountryCode |
|
|
| csySummerTimeStatus |
1.3.6.1.4.1.9.9.131.1.3.1 |
| An indication of whether the summertime feature
is enabled on this device. When this object
is set to true, then csySummerTimeOffset,
csySummerTimeRecurringStart and
csySummerTimeRecurringEnd objects are set
to default values provided by the system.
When this object is set
to false, then csySummerTimeOffset,
csySummerTimeRecurringStart,
csySummerTimeRecurringEnd objects are
not instantiated and the summertime feature
is disabled. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
TruthValue |
|
|
| csySummerTimeOffset |
1.3.6.1.4.1.9.9.131.1.3.2 |
| The value of this object indicates number of
minutes to add or to subtract during summertime.
This object is not instantiated when
csySummerTimeStatus object is set to false. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
1..1440 |
|
| csySummerTimeRecurringStart |
1.3.6.1.4.1.9.9.131.1.3.3 |
| Indicates summertime starts at this time every year.
octets contents range
1 week 1..5,ff last = ff
2-3 day 1..7
where sunday = 1 saturday = 7
4 month 1..12
where january = 1 december = 12
5 hour 0..23
6 min 0..59
For example, the first Monday in Feb at 13:30pm
should be given as
01 00 02 02 0e 1e
For the last Tuesday in dec at 1:20am should be
given as
ff 00 03 0c 01 14
This object is not instantiated when
csySummerTimeStatus object is set to false. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
OCTET STRING |
Size(6) |
|
| csySummerTimeRecurringEnd |
1.3.6.1.4.1.9.9.131.1.3.4 |
| Indicates summertime ends at this time every year.
octets contents range
1 week 1..5,ff where ff = last
2-3 day 1..7
where sunday = 1 saturday = 7
4 month 1..12
where january = 1 december = 12
5 hour 0..23
6 min 0..59
For example, the third friday in February at 3:30am
should be given as
03 00 06 02 03 1e
For the first Tuesday in May at 1:20am should
be given as
01 00 03 05 01 14
This object is not instantiated when
csySummerTimeStatus object is set to false. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
OCTET STRING |
Size(6) |
|
| csyStandardTmZnGMTOffset |
1.3.6.1.4.1.9.9.131.1.3.5 |
| This object is used to set standard timezone offset from GMT
in minutes. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
Integer32 |
-720..720 |
|
| csySummerTmZnGMTOffset |
1.3.6.1.4.1.9.9.131.1.3.6 |
| This object is used to set summer timezone offset from GMT in
minutes. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
Integer32 |
-720..720 |
|
| csyScheduledResetTime |
1.3.6.1.4.1.9.9.131.1.4.1 |
| The scheduled date and time the switch will be
reset at. The system will only take octet strings
with length 8 for this object which indicates the
local time of the switch. The maximum scheduled
time is 24 days from the current system clock time.
Setting this object value to be before the current
system clock time or beyond the maximum scheduled
time limit will be rejected by the system. Setting
the object to all-zero octet strings will cancel the
previously scheduled reset time and then the system
will have no pending scheduled reset time. Setting
this object value to be any valid octet strings
other than the above cases will override the
previously scheduled reset time and cause the system
to be reset at the newly specified time.
After the system has accepted the scheduled reset
time, if the system clock is advanced ahead of the
scheduled reset time, then reset will happen
approximately 5 minutes after the current clock. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
DateAndTime |
|
|
| csyScheduledResetAction |
1.3.6.1.4.1.9.9.131.1.4.2 |
| Writing reset(1) to this object perform the normal
reset operation on the active supervisor module.
Writing resetMinDown(2) to this object resets the
system with the minimal system down time at the
scheduled time. The resetMinDown(2) is only
supported in systems with redundant supervisors. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
reset(1), resetMinDown(2) |
|
| csyScheduledResetReason |
1.3.6.1.4.1.9.9.131.1.4.3 |
| Indicates the reason users input when issuing
system's scheduled reset. After the system
is reset, this object value will be empty octet
string. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
DisplayString |
|
|
| csySnmpAuthFail |
1.3.6.1.4.1.9.9.131.1.5.1 |
| The total number of SNMP messages received by the SNMP engine
that were not properly authenticated. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
Counter32 |
|
|
| csySnmpAuthFailAddressType |
1.3.6.1.4.1.9.9.131.1.5.2 |
| The type of Internet address by which the last received
SNMP message that is not properly authenticated.
The value of this object is irrelevant if the value of
csySnmpAuthFail is zero. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
InetAddressType |
|
|
| csySnmpAuthFailAddress |
1.3.6.1.4.1.9.9.131.1.5.3 |
| The internet address of the SNMP entity which sent the
last received SNMP message that is not properly authenticated.
The value of this object is irrelevant if the value of
csySnmpAuthFail is zero. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
InetAddress |
|
|
| csyNotificationsEnable |
1.3.6.1.4.1.9.9.131.1.6.1 |
| This object indicates whether the system produces the
notifications defined by the ciscoSystemNotificationsGroup.
A false value will prevent notifications from being generated
by this system. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
TruthValue |
|
|
| ciscoSystemClockChanged |
1.3.6.1.4.1.9.9.131.2.0.1 |
| A clock changed notification is generated when the current
local date and time for the system has been manually changed.
The value of csyClockDateAndTime reflects new date and time. |
| Status: current |
Access: read-write |
| NOTIFICATION-TYPE |
|
|
|
| ciscoSystemMIBCompliance |
1.3.6.1.4.1.9.9.131.3.1.1 |
| The compliance statement for entities which implement
the Cisco System MIB. Adherence to this compliance
statement is expected of all Cisco systems. |
| Status: deprecated |
Access: read-only |
| MODULE-COMPLIANCE |
|
|
|
| ciscoSystemMIBCompliance2 |
1.3.6.1.4.1.9.9.131.3.1.2 |
| The compliance statement for entities which implement
the Cisco System MIB. Adherence to this compliance
statement is expected of all Cisco systems. |
| Status: deprecated |
Access: read-only |
| MODULE-COMPLIANCE |
|
|
|
| ciscoSystemMIBCompliance3 |
1.3.6.1.4.1.9.9.131.3.1.3 |
| The compliance statement for entities which implement
the Cisco System MIB. Adherence to this compliance
statement is expected of all Cisco systems. |
| Status: deprecated |
Access: read-only |
| MODULE-COMPLIANCE |
|
|
|
| ciscoSystemMIBCompliance4 |
1.3.6.1.4.1.9.9.131.3.1.4 |
| The compliance statement for entities which implement
the Cisco System MIB. Adherence to this compliance
statement is expected of all Cisco systems. |
| Status: current |
Access: read-only |
| MODULE-COMPLIANCE |
|
|
|
| ciscoSystemClockGroup |
1.3.6.1.4.1.9.9.131.3.2.1 |
| Clock attributes. |
| Status: current |
Access: read-only |
| OBJECT-GROUP |
|
|
|
| ciscoSystemLocationGroup |
1.3.6.1.4.1.9.9.131.3.2.2 |
| Physical location attributes. |
| Status: current |
Access: read-only |
| OBJECT-GROUP |
|
|
|
| ciscoSystemSummerTimeGroup |
1.3.6.1.4.1.9.9.131.3.2.3 |
| A collection of objects used to set Summertime.
Implementation of this group is optional. If the
generic Summertime feature is supported, the entire
group should be implemented. |
| Status: deprecated |
Access: read-only |
| OBJECT-GROUP |
|
|
|
| ciscoSystemScheduledResetGroup |
1.3.6.1.4.1.9.9.131.3.2.4 |
| A collection of objects used to set scheduled reset time.
Implementation of this group is optional. If the system
scheduled reset feature is supported, the entire group
should be implemented. |
| Status: current |
Access: read-only |
| OBJECT-GROUP |
|
|
|
| ciscoSystemSnmpAuthGroup |
1.3.6.1.4.1.9.9.131.3.2.5 |
| A collection of objects which provide information
about SNMP message that is not properly authenticated. |
| Status: current |
Access: read-only |
| OBJECT-GROUP |
|
|
|
| ciscoSystemGeneralGroup |
1.3.6.1.4.1.9.9.131.3.2.6 |
| A collection of objects which provide information
about general configuration within this MIB module. |
| Status: current |
Access: read-only |
| OBJECT-GROUP |
|
|
|
| ciscoSystemNotificationsGroup |
1.3.6.1.4.1.9.9.131.3.2.7 |
| A collection of notifications in this MIB module. |
| Status: current |
Access: read-only |
| NOTIFICATION-GROUP |
|
|
|
| ciscoSystemSummerTimeGroupRev1 |
1.3.6.1.4.1.9.9.131.3.2.8 |
| A collection of objects used to set Summertime.
Implementation of this group is optional. If the
generic Summertime feature is supported, the entire
group should be implemented. |
| Status: current |
Access: read-only |
| OBJECT-GROUP |
|
|
|