CISCO-L2L3-INTERFACE-CONFIG-MIB
File:
CISCO-L2L3-INTERFACE-CONFIG-MIB.mib (5337 bytes)
Imported modules
Imported symbols
Defined Types
CL2L3InterfaceMode |
|
The operational mode of the interface.
For administrative and operational states, valid values are:
routed(1), switchport(2).
routed(1): Routed mode interfaces direct traffic using
layer 3 protocols.
switchport(2): Switchport-mode interfaces direct traffic using
layer 2 protocols. A switchport-mode interface can be in
access mode, or trunk mode, or multi-mode.
Switchport interface operating mode can be configured manually,
or negotiated by Dynamic Trunking Protocol (DTP) or Dynamic
Inter-Switch Link (DISL).
Access-mode interfaces carry one VLAN's traffic. Access-mode
interface parameters are configured in CISCO-VLAN-MEMBERSHIP-MIB.
Trunk-mode interfaces carry one or more VLANs. VLAN-related
trunk-mode interface parameters are configured in CISCO-VTP-MIB.
Multi-mode interfaces carry one VLAN to each alias of a
single connected end-station. VLAN-related multi-mode
interface parameters are configured in CISCO-VTP-MIB.
|
TEXTUAL-CONVENTION |
|
|
|
|
INTEGER |
routed(1), switchport(2) |
|
Defined Values
ciscoL2L3IfConfigMIB |
1.3.6.1.4.1.9.9.151 |
Interface switchport mode configuration management MIB.
This MIB is used to monitor and control
configuration of interface switchport and routed mode. |
MODULE-IDENTITY |
|
|
|
cL2L3IfTable |
1.3.6.1.4.1.9.9.151.1.1.1 |
The table shows the administratively requested and
actual operating configuration for switchport interfaces. |
Status: current |
Access: not-accessible |
OBJECT-TYPE |
|
|
|
|
SEQUENCE OF |
|
|
|
|
CL2L3IfEntry |
|
cL2L3IfEntry |
1.3.6.1.4.1.9.9.151.1.1.1.1 |
An entry represents the configuration and operation of a
switchport interface.
Entries are created and deleted automatically in tandem
with the corresponding ifEntries. |
Status: current |
Access: not-accessible |
OBJECT-TYPE |
|
|
|
|
CL2L3IfEntry |
|
|
ciscoL2L3IfConfigMIBCompliance |
1.3.6.1.4.1.9.9.151.3.1.1 |
The compliance statement for entities which implement
the Cisco L2L3 Interface Configuration Management MIB |
Status: current |
Access: read-only |
MODULE-COMPLIANCE |
|
|
|
ciscoL2L3IfConfigMIBGroup |
1.3.6.1.4.1.9.9.151.3.2.1 |
Interface L2 & L3 mode objects |
Status: current |
Access: read-only |
OBJECT-GROUP |
|
|
|