CASA-CABLE-CMQUERY-MIB
File:
CASA-CABLE-CMQUERY-MIB.mib (7340 bytes)
Imported modules
Imported symbols
Defined Types
TenthdBmV |
|
This data type represents power levels that are normally
expressed in dBmV. Units are in tenths of a dBmV;
for example, 5.1 dBmV will be represented as 51. |
TEXTUAL-CONVENTION |
|
|
|
|
Integer32 |
|
|
TenthdB |
|
This data type represents power levels that are normally
expressed in dB. Units are in tenths of a dB;
for example, 5.1 dB will be represented as 51. |
TEXTUAL-CONVENTION |
|
|
|
|
Integer32 |
|
|
CasaCmQueryEntry |
|
SEQUENCE |
|
|
|
|
casaQueryCmMacAddress |
MacAddress |
|
|
casaQueryCmIpAddress |
IpAddress |
|
|
casaQueryCmTxTimeOffset |
Unsigned32 |
|
|
casaQueryCmMicroReflection |
Integer32 |
|
|
casaQueryCmStatusTxPower |
TenthdBmV |
|
|
casaQueryCmStatusRxPower |
TenthdBmV |
|
|
casaQueryCmSigQSignalNoise |
TenthdB |
|
|
casaQueryCmtsSigQSignalNoise |
TenthdB |
|
Defined Values
casaCmQueryMib |
1.3.6.1.4.1.20858.10.18 |
This is the enterprise MIB Module for CASA systems CMTS. |
MODULE-IDENTITY |
|
|
|
casaMgmt |
1.3.6.1.4.1.20858.10 |
OBJECT IDENTIFIER |
|
|
|
casaCmQueryTable |
1.3.6.1.4.1.20858.10.18.1.1 |
describes the PHY signal quality and Tx/Rx parameter of cable modem.
|
Status: current |
Access: not-accessible |
OBJECT-TYPE |
|
|
|
|
SEQUENCE OF |
|
|
|
|
CasaCmQueryEntry |
|
casaCmQueryEntry |
1.3.6.1.4.1.20858.10.18.1.1.1 |
describes the PHY signal quality and Tx/Rx parameter of cable modem,index of this table is casaQueryCmMacAddress.
|
Status: current |
Access: not-accessible |
OBJECT-TYPE |
|
|
|
|
CasaCmQueryEntry |
|
|
casaQueryCmTxTimeOffset |
1.3.6.1.4.1.20858.10.18.1.1.1.3 |
A measure of the current round trip time at the CM, or the
maximum round trip time seen by the CMTS. Used for timing
of CM upstream transmissions to ensure synchronized
arrivals at the CMTS. Units are in terms of
(6.25 microseconds/64). |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Unsigned32 |
|
|
casaQueryCmMicroReflection |
1.3.6.1.4.1.20858.10.18.1.1.1.4 |
Total microreflections including in-channel response
as perceived on this interface, measured in dBc below
the signal level.
This object is not assumed to return an absolutely
accurate value, but should give a rough indication
of microreflections received on this interface.
It is up to the implementor to provide information
as accurate as possible.
|
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Integer32 |
0..255 |
|
casaQueryCmStatusTxPower |
1.3.6.1.4.1.20858.10.18.1.1.1.5 |
The operational transmit power of the cable modem downstream channel,the most current value (CM)
or the value of 0.
|
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
TenthdBmV |
|
|
casaQueryCmStatusRxPower |
1.3.6.1.4.1.20858.10.18.1.1.1.6 |
The operational receive power of the cable modem upstream channel,the most current value (CM)
or the value of 0 |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
TenthdBmV |
|
|
casaQueryCmSigQSignalNoise |
1.3.6.1.4.1.20858.10.18.1.1.1.7 |
Signal/Noise ratio as perceived for this channel.
describes the Signal/Noise of the upstream
channel of CM .
|
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
TenthdB |
|
|
casaQueryCmtsSigQSignalNoise |
1.3.6.1.4.1.20858.10.18.1.1.1.8 |
Signal/Noise ratio as perceived for this channel.
describes the average Signal/Noiseof the upstream
channel of CMTS.
|
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
TenthdB |
|
|
casaCmQueryroup |
1.3.6.1.4.1.20858.10.18.2.1 |
Box is required to support objects in this group
|
Status: current |
Access: read-only |
OBJECT-GROUP |
|
|
|
casaCmQueryCompliance |
1.3.6.1.4.1.20858.10.18.3.1 |
Description. |
Status: current |
Access: read-only |
MODULE-COMPLIANCE |
|
|
|