JUNIPER-WX-EVENT-MIB
File:
JUNIPER-WX-EVENT-MIB.mib (5362 bytes)
Imported modules
Imported symbols
Defined Values
| jnxWxGrpEventV2 |
1.3.6.1.4.1.2636.3.41.1.1.3.0 |
|
Branch for SNMPv2 events. The OIDs for SNMPv2 events should
have a zero as the next-to-last sub-identifier (as specified
in RFC1902).
|
| Status: current |
Access: accessible-for-notify |
| OBJECT-IDENTITY |
|
|
|
| jnxWxGrpEventDescr |
1.3.6.1.4.1.2636.3.41.1.1.3.1 |
|
String that provides a textual description of the event.
|
| Status: current |
Access: accessible-for-notify |
| OBJECT-TYPE |
|
|
|
| |
DisplayString |
|
|
| jnxWxGrpEventPowerSupplyFailure |
1.3.6.1.4.1.2636.3.41.1.1.3.0.1 |
| One or more sources of power to the system have failed.
A redundant power-supply has presumably taken over.
|
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventPowerSupplyOk |
1.3.6.1.4.1.2636.3.41.1.1.3.0.2 |
| One or more previously failed sources of power is now
working normally. The transition to normal condition happened
without the system having to be restarted.
|
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventLicenseWillExpire |
1.3.6.1.4.1.2636.3.41.1.1.3.0.3 |
| The license for the system is about to
expire shortly. When it eventually does
expire, the system will switch over to
and stay in pass-through mode. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventThruputLimitExceeded |
1.3.6.1.4.1.2636.3.41.1.1.3.0.4 |
| The throughput of traffic through the device
has exceeded the limit for which it has
been licensed. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventLicenseExpired |
1.3.6.1.4.1.2636.3.41.1.1.3.0.5 |
| The license for the system expired.
As a result, the system will switch over to
and stay in pass-through mode. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventClientLimitExceeded |
1.3.6.1.4.1.2636.3.41.1.1.3.0.6 |
| Exceeded licensed maximum concurrent client connections.
Please contact Juniper Networks to obtain a new license
with higher number of concurrent client connections. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventInFailSafeMode |
1.3.6.1.4.1.2636.3.41.1.1.3.0.7 |
| This trap is sent when the device boots up in fail-safe mode.
This can happen for one of the following reasons:
Fail-safe reboot was explicitly initiated by the user.
The device rebooted automatically too many times because of
the failure of internal consistency checks or the failure of
tests that verify proper operation of the device. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventInterfaceSpeedMismatch |
1.3.6.1.4.1.2636.3.41.1.1.3.0.8 |
| A mismatch is detected between the local and remote
interface settings. This can happen due to a mismatch
in the local and remote interface speed or mode. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventInterfaceSpeedOk |
1.3.6.1.4.1.2636.3.41.1.1.3.0.9 |
| A mismatch previously detected between the local and remote
interface settings is now resolved. The local and remote
interface speed and mode are matched. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventInterfaceDuplexMismatch |
1.3.6.1.4.1.2636.3.41.1.1.3.0.10 |
| A possible mismatch was detected between the duplex settings
of either the local or remote interface and that of the
device attached to that interface. The interface (local
or remote) is identified by the 'ifIndex' object.
Note that this notification is quite different from
jnxWxGrpEventInterfaceSpeedMismatch, which compares the
local and remote interfaces on the same WX device. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventLoginFailure |
1.3.6.1.4.1.2636.3.41.1.1.3.0.11 |
| A user's login attempt via the console/ssh/web server
failed due to incorrect username or password. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|
| jnxWxGrpEventDiskFailure |
1.3.6.1.4.1.2636.3.41.1.1.3.0.12 |
| A hard disk failed on the system. The system was rebooted,
and will now operate without the downed disk, at a degraded
performance. Dictionary accumulated until this point was lost. |
| Status: current |
Access: accessible-for-notify |
| NOTIFICATION-TYPE |
|
|
|