IPV4-MIB
File:
IPV4-MIB.mib (11854 bytes)
Imported modules
Imported symbols
Defined Types
APIpv4RedundancyLinkFailEntry |
|
SEQUENCE |
|
|
|
|
apIpv4RedundancyLinkFailIfIndex |
INTEGER |
|
|
apIpv4RedundancyLinkStatus |
RowStatus |
|
Defined Values
apIpv4Mib |
1.3.6.1.4.1.2467.1.9.1.1 |
This MIB module describes the ArrowPoint enterprise
MIB support for IPv4 Global Information |
MODULE-IDENTITY |
|
|
|
apIpv4SourceRoute |
1.3.6.1.4.1.2467.1.9.1.2 |
If enabled, IP packets with a source route option will be
processed. If disabled, they are dropped. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
enable(1), disable(2) |
|
apIpv4RecordRoute |
1.3.6.1.4.1.2467.1.9.1.3 |
If enabled, IP packets with a record route option will be
processed. If disabled, they are dropped. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
enable(1), disable(2) |
|
apIpv4SubnetBcast |
1.3.6.1.4.1.2467.1.9.1.4 |
If enabled, IP packets addressed to a broadcast address of a local
subnet will be forwarded. If disabled, they are dropped. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
enable(1), disable(2) |
|
apIpv4EcmpMethod |
1.3.6.1.4.1.2467.1.9.1.5 |
Defines the algorithm to use when multiple equal-cost paths are
available to the same destination. 'address' uses the IP addresses
to assign a path. 'round' does a simple round-robin. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
address(1), round(2) |
|
apIpv4OrphanTimer |
1.3.6.1.4.1.2467.1.9.1.6 |
The amount of time, in seconds, that a route will be kept after
an SCM recovery. Default is 3 minutes. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
|
|
apIpv4LogRouteChanges |
1.3.6.1.4.1.2467.1.9.1.7 |
If enabled, IP route changes will be displayed in the system log. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
enable(1), disable(2) |
|
apIpv4ReachRoutes |
1.3.6.1.4.1.2467.1.9.1.8 |
Current number of reachable routes. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4ReachRoutesMem |
1.3.6.1.4.1.2467.1.9.1.9 |
Amount of memory used to maintain reachable routes. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4TotalRoutes |
1.3.6.1.4.1.2467.1.9.1.10 |
Current number of routes maintainted, both reachable and
unreachable. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4TotalRoutesMem |
1.3.6.1.4.1.2467.1.9.1.11 |
Amount of memory used to maintain all routes. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4ReachHosts |
1.3.6.1.4.1.2467.1.9.1.12 |
Current number of reachable host entries. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4ReachHostsMem |
1.3.6.1.4.1.2467.1.9.1.13 |
Amount of memory used to maintain reachable host entries. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4TotalHosts |
1.3.6.1.4.1.2467.1.9.1.14 |
Current number of host entries maintainted, both reachable and
unreachable. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4TotalHostsMem |
1.3.6.1.4.1.2467.1.9.1.15 |
Amount of memory used to maintain all host entries. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4PoolMem |
1.3.6.1.4.1.2467.1.9.1.16 |
Amount of memory held in IP routing table pool. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
Gauge32 |
|
|
apIpv4B2BRedundancy |
1.3.6.1.4.1.2467.1.9.1.17 |
Indicates whether box-to-box redundancy is configured on
this box. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
TruthValue |
|
|
apIpv4Opportunistic |
1.3.6.1.4.1.2467.1.9.1.18 |
Indicates the operating mode for layer-3 opportunistic forwarding.
In 'local' mode (the default), packets whose IP address equals
a resolved node attached to a local subnet will be forwarded
to that node regardless of the destination MAC address of the
packet. In 'all' mode, packets whose IP address matches any
reachable IP routing entry will be forwarded according to the
routing entry regardless of the destination MAC address of the
packet. In 'disable' mode, only packets whose destination MAC
address equal this node's MAC address will be forwarded using
an IP route entry. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
local(1), all(2), disable(3) |
|
apIpv4RedundancyState |
1.3.6.1.4.1.2467.1.9.1.19 |
The current redundancy state |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
init(1), backup(2), master(3) |
|
apIpv4RedundancyIf |
1.3.6.1.4.1.2467.1.9.1.20 |
The IP address of the redundant link |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
IpAddress |
|
|
apIpv4RedundancyMasterMode |
1.3.6.1.4.1.2467.1.9.1.22 |
Indicates whether box-to-box redundancy is configured to
always be the master. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
TruthValue |
|
|
apIpv4EcmpSticky |
1.3.6.1.4.1.2467.1.9.1.23 |
This object specifies whether when making an ECMP
decision on the return port, should the ingress
port be the preferred path. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
enabled(1), disabled(0) |
|
apIpv4ImplicitService |
1.3.6.1.4.1.2467.1.9.1.24 |
This object specifies whether when configuring a static
route, if an implicit service should be started for the
next hop address. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
INTEGER |
enabled(1), disabled(0) |
|
apIpv4RedundancyLinkFailEntry |
1.3.6.1.4.1.2467.1.9.1.25.1 |
An entry in the IP redundancy Interface failure monitor table. |
Status: current |
Access: not-accessible |
OBJECT-TYPE |
|
|
|
|
APIpv4RedundancyLinkFailEntry |
|
|
apIpv4RedundancyLinkFailIfIndex |
1.3.6.1.4.1.2467.1.9.1.25.1.1 |
Interface Index used to uniquely identify ethernet interface |
Status: current |
Access: read-create |
OBJECT-TYPE |
|
|
|
|
INTEGER |
1..1024 |
|
apIpv4RedundancyFailReason |
1.3.6.1.4.1.2467.1.9.1.26 |
The redundancy state change reason |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
noFailure(0), phylinkFail(1), uplinkFailure(2), otherSwitchAssertMaster(3) |
|
apIpv4VrrpVRID |
1.3.6.1.4.1.2467.1.9.1.27 |
This object tells virtual router ID in vrrp protocol. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
0..255 |
|
apIpv4VrrpPriority |
1.3.6.1.4.1.2467.1.9.1.28 |
This object tells virtual router priority in vrrp. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
0..255 |
|
apIpv4numUplinkServices |
1.3.6.1.4.1.2467.1.9.1.29 |
This object tells number of uplink services enabled. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
0..512 |
|
apIpv4numViableUplinks |
1.3.6.1.4.1.2467.1.9.1.30 |
This object tells number of uplink services alive. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
0..512 |
|
apIpv4numPhylinkMarked |
1.3.6.1.4.1.2467.1.9.1.31 |
This object tells number of redundant-physical links monitored. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
0..5 |
|
apIpv4toMasterStateCnt |
1.3.6.1.4.1.2467.1.9.1.32 |
This object tells number of times the box become master. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
0..1024 |
|
apIpv4toBackupStateCnt |
1.3.6.1.4.1.2467.1.9.1.33 |
This object tells number of times the box become backup. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
0..1024 |
|