HPN-ICF-LAG-MIB
File:
HPN-ICF-LAG-MIB.mib (12463 bytes)
Imported modules
Imported symbols
Defined Types
| HpnicfAggLinkEntry |
|
| SEQUENCE |
|
|
|
| |
hpnicfAggLinkNumber |
Integer32 |
|
| |
hpnicfAggLinkName |
DisplayString |
|
| |
hpnicfAggLinkMode |
INTEGER |
|
| |
hpnicfAggLinkPortList |
PortList |
|
| |
hpnicfAggLinkState |
RowStatus |
|
| |
hpnicfAggPortListSelectedPorts |
PortList |
|
| |
hpnicfAggPortListSamePartnerPorts |
PortList |
|
| HpnicfAggPortEntry |
|
| SEQUENCE |
|
|
|
| |
hpnicfAggPortIndex |
Gauge32 |
|
| |
hpnicfAggPortNotAttachedReason |
Integer32 |
|
| |
hpnicfAggPortLacpState |
TruthValue |
|
| |
hpnicfAggPortNotAttachedString |
DisplayString |
|
Defined Values
| hpnicfLAG |
1.3.6.1.4.1.11.2.14.11.15.8.25 |
| LACP extend MIB. |
| MODULE-IDENTITY |
|
|
|
| hpnicfAggLinkEntry |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.1.1 |
| Entry of table. |
| Status: current |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
HpnicfAggLinkEntry |
|
|
| hpnicfAggLinkNumber |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.1.1.1 |
| The serial number of aggregation group. |
| Status: current |
Access: accessible-for-notify |
| OBJECT-TYPE |
|
|
|
| |
Integer32 |
|
|
| hpnicfAggLinkMode |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.1.1.3 |
| Type of aggregation.
manual: Manual aggregation, no LACP.
static: Membership specified by user, LACP is
used to validate.
dynamic: Completely dynamic aggregation detected
by LACP. |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
INTEGER |
manual(1), static(2), dynamic(3) |
|
| hpnicfAggLinkPortList |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.1.1.4 |
| List of ports in this link aggregation group, by bridge port
number. If the mode of the link aggregation group is manual
or static, you can update this list to your
hearts content. However, if the link aggregation group is
dynamic, the system will maintain it. You are not
permitted to set the value of this to
all zeroes. |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
PortList |
|
|
| hpnicfAggLinkState |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.1.1.5 |
| RowStatus, now support three states:
createAndGo, active, destroy. |
| Status: current |
Access: read-create |
| OBJECT-TYPE |
|
|
|
| |
RowStatus |
|
|
| hpnicfAggPortListSelectedPorts |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.1.1.6 |
| A PortList of physical ports that have been
selected but not attached to this aggregator.
When the bit is set to 1,it means the
corresponding port is in the portlist. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
PortList |
|
|
| hpnicfAggPortListSamePartnerPorts |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.1.1.7 |
| PortList of physical ports that have the
same Actor SystemID and partner systemID as
this aggregator, but have different actor
and partner keys of aggregator. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
PortList |
|
|
| hpnicfAggPortEntry |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.2.1 |
| Entry of table. |
| Status: current |
Access: not-accessible |
| OBJECT-TYPE |
|
|
|
| |
HpnicfAggPortEntry |
|
|
| hpnicfAggPortIndex |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.2.1.1 |
| Port ifindex which is according to RFC1213 MIB. |
| Status: current |
Access: accessible-for-notify |
| OBJECT-TYPE |
|
|
|
| |
Gauge32 |
|
|
| hpnicfAggPortNotAttachedReason |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.2.1.2 |
| Reason why this port is selected for an
aggregator but not attached,
0: The port is attached to this aggregator.
1: The current number of active ports has
reached the upper limit.
2: All aggregation resources are already in-use.
3: The port's configuration is improper
for being attached.
4: The port's partner is improper for being attached.
5: The number of current active ports
has not reached the lower limit.
6: The port's physical state (down) is
improper for being attached.
7: The port is not selected for an aggregator.
8: The port's hardware restriction is
improper for being attached.
9: The port's speed is improper for being attached.
10: The port's duplex mode is improper for being attached. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
Integer32 |
0..10 |
|
| hpnicfAggPortNotAttachedString |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.2.1.4 |
| The string which interprets this
port is selected for an aggregator
but not attached. |
| Status: current |
Access: read-write |
| OBJECT-TYPE |
|
|
|
| |
DisplayString |
Size(0..255) |
|
| hpnicfAggResourceAllocationValue |
1.3.6.1.4.1.11.2.14.11.15.8.25.1.3 |
| The priority value calculated to decide which
aggregations have first call on the load-sharing
aggregation resources in the hardware. It
depends on the aggregation type and total
speed. |
| Status: current |
Access: read-only |
| OBJECT-TYPE |
|
|
|
| |
PortList |
|
|
| hpnicfAggSpeedChangedNotification |
1.3.6.1.4.1.11.2.14.11.15.8.25.2.1 |
| This event will be triggered whenever an
aggregation changes its speed. |
| Status: current |
Access: read-only |
| NOTIFICATION-TYPE |
|
|
|
| hpnicfAggPortInactiveNotification |
1.3.6.1.4.1.11.2.14.11.15.8.25.2.2 |
| This event will be triggered whenever any port
in aggregator is made inactive. |
| Status: current |
Access: read-only |
| NOTIFICATION-TYPE |
|
|
|
| hpnicfAggPortInactiveNotification2 |
1.3.6.1.4.1.11.2.14.11.15.8.25.2.3 |
| This event will be triggered whenever the port
in aggregator is made inactive. |
| Status: current |
Access: read-only |
| NOTIFICATION-TYPE |
|
|
|
| hpnicfAggPortActiveNotification |
1.3.6.1.4.1.11.2.14.11.15.8.25.2.4 |
| This event will be triggered whenever the port
in aggregator is made active. |
| Status: current |
Access: read-only |
| NOTIFICATION-TYPE |
|
|
|
| hpnicfLAGMibCompliance |
1.3.6.1.4.1.11.2.14.11.15.8.25.3.1.1 |
| The compliance statement for SNMP entities
which implement the Lag MIB. |
| Status: current |
Access: read-only |
| MODULE-COMPLIANCE |
|
|
|
| hpnicfLAGMibObjectGroup |
1.3.6.1.4.1.11.2.14.11.15.8.25.3.2.1 |
| The collection of objects which are used to
represent LAG objects. |
| Status: current |
Access: read-only |
| OBJECT-GROUP |
|
|
|
| hpnicfLAGMibNotificationGroup |
1.3.6.1.4.1.11.2.14.11.15.8.25.3.2.2 |
| The collection of objects which are used to
represent notifications. |
| Status: current |
Access: read-only |
| NOTIFICATION-GROUP |
|
|
|