HPN-ICF-FCOE-MODE-MIB

File: HPN-ICF-FCOE-MODE-MIB.mib (2896 bytes)

Imported modules

SNMPv2-SMI HPN-ICF-OID-MIB

Imported symbols

Integer32 OBJECT-TYPE MODULE-IDENTITY
hpnicfCommon

Defined Values

hpnicfFcoeMode 1.3.6.1.4.1.11.2.14.11.15.2.135
This MIB module is for configuring and monitoring the working mode of FCoE (Fibre Channel over Ethernet) features.
MODULE-IDENTITY    

hpnicfFcoeModeMibObjects 1.3.6.1.4.1.11.2.14.11.15.2.135.1
OBJECT IDENTIFIER    

hpnicfFcoeModeCfgMode 1.3.6.1.4.1.11.2.14.11.15.2.135.1.1
This object specifies the FCoE modes the switch supports. The object has four available values: 1: non-FCoE mode. 2: FCF mode. 3: NPV mode. 4: Transit mode. The switch mode can only be converted from non-FCoE mode to one of FCoE modes, or vice versa, but cannot be converted directly among the other three FCoE modes. To convert among the other three FCoE modes, the switch should first be converted to non-FCoE mode. After converting the switch to non-FCoE mode, FCoE-related configurations in the original FCoE mode will be cleared.
OBJECT-TYPE    
  Integer32  

hpnicfFcoeModeCfgLastResult 1.3.6.1.4.1.11.2.14.11.15.2.135.1.2
This object specifies the result of the latest FCoE mode configuration. The object has four values: success - Configured successfully. noLicence - Configured unsuccessfully for lack of licence. needReset - Configured unsuccessfully, because the desired mode is not non-FCoE mode, and the mode should be first set to non-FCoE mode. unknownFault - Configured unsuccessfully for unknown fault.
OBJECT-TYPE    
  INTEGER success(1), noLicence(2), needReset(3), unknownFault(4)