H3C-FCOE-MODE-MIB
File:
H3C-FCOE-MODE-MIB.mib (3054 bytes)
Imported modules
Imported symbols
Defined Values
h3cFcoeMode |
1.3.6.1.4.1.2011.10.2.135 |
This MIB module is for configuring and monitoring the working mode of
FCoE (Fibre Channel over Ethernet) features. |
MODULE-IDENTITY |
|
|
|
h3cFcoeModeCfgMode |
1.3.6.1.4.1.2011.10.2.135.1.1 |
This object specifies the FCoE modes the switch supports.
The object has four available values:
1: non-FCoE mode.
2: FCF mode.
3: NPV mode.
4: Transit mode.
The switch mode can only be converted from non-FCoE mode to one of FCoE
modes, or vice versa, but cannot be converted directly among the other
three FCoE modes.
To convert among the other three FCoE modes, the switch should first
be converted to non-FCoE mode. After converting the switch to non-FCoE
mode, FCoE-related configurations in the original FCoE mode will be
cleared. |
Status: current |
Access: read-write |
OBJECT-TYPE |
|
|
|
|
Integer32 |
|
|
h3cFcoeModeCfgLastResult |
1.3.6.1.4.1.2011.10.2.135.1.2 |
This object specifies the result of the latest FCoE mode configuration.
The object has four values:
success - Configured successfully.
noLicence - Configured unsuccessfully for lack of licence.
needReset - Configured unsuccessfully, because the desired mode is
not non-FCoE mode, and the mode should be first set to
non-FCoE mode.
unknownFault - Configured unsuccessfully for unknown fault. |
Status: current |
Access: read-only |
OBJECT-TYPE |
|
|
|
|
INTEGER |
success(1), noLicence(2), needReset(3), unknownFault(4) |
|