GBOND-ATM-MIB

File: GBOND-ATM-MIB.mib (13352 bytes)

Imported modules

SNMPv2-SMI SNMPv2-TC SNMPv2-CONF
IF-MIB GBOND-MIB

Imported symbols

MODULE-IDENTITY OBJECT-TYPE NOTIFICATION-TYPE
Unsigned32 Counter32 TimeTicks
TEXTUAL-CONVENTION TruthValue MODULE-COMPLIANCE
OBJECT-GROUP NOTIFICATION-GROUP ifIndex
InterfaceIndex gBondMIB

Defined Types

GBondAtmPortConfEntry  
SEQUENCE    
  gBondAtmUpMaxDataRate Unsigned32
  gBondAtmDownMaxDataRate Unsigned32
  gBondAtmUpDiffDelayTolerence Unsigned32
  gBondAtmDownDiffDelayTolerence Unsigned32

GBondAtmPortStatusEntry  
SEQUENCE    
  gBondAtmShowTime TimeTicks
  gBondAtmUpRxCellLossCount Counter32
  gBondAtmDownRxCellLossCount Counter32

Defined Values

gBondAtmMIB 1.3.6.1.2.1.211.1
The objects in this MIB module are used to manage the multi-pair bonded xDSL Interfaces using ATM inverse multiplexing, defined in ITU-T recommendation G.998.1 (G.Bond/ATM). This MIB module MUST be used in conjunction with GBOND-MIB module, common to all G.Bond technologies. The following references are used throughout this MIB module: [WT-159] refers to: DSL Forum Technical Report: 'Management Framework for xDSL Bonding', January 2007. Naming Conventions: BCE - Bonding Channel Entity CO - Central Office CPE - Customer Premises Equipment GBS - Generic Bonding Sublayer SNR - Signal to Noise Ratio Copyright (C) The Internet Society (2007). This version of this MIB module is part of RFC XXXX; see the RFC itself for full legal notices.
MODULE-IDENTITY    

gBondAtmObjects 1.3.6.1.2.1.211.1.1
OBJECT IDENTIFIER    

gBondAtmConformance 1.3.6.1.2.1.211.1.2
OBJECT IDENTIFIER    

gBondAtmPort 1.3.6.1.2.1.211.1.1.1
OBJECT IDENTIFIER    

gBondAtmPortConfTable 1.3.6.1.2.1.211.1.1.1.1
Table for Configuration of G.Bond ATM ports. Entries in this table MUST be maintained in a persistent manner
OBJECT-TYPE    
  SEQUENCE OF  
    GBondAtmPortConfEntry

gBondAtmPortConfEntry 1.3.6.1.2.1.211.1.1.1.1.1
An entry in the G.Bond ATM Port Configuration table. Each entry represents an G.Bond ATM port indexed by the ifIndex. Additional configuration parameters are available via the gBondPortConfEntry of GBOND-MIB. Note that an G.Bond ATM port runs on top of a single or multiple BCE port(s), which are also indexed by ifIndex.
OBJECT-TYPE    
  GBondAtmPortConfEntry  

gBondAtmUpMaxDataRate 1.3.6.1.2.1.211.1.1.1.1.1.1
The maximum net upstream data rate a bonding group is allowed to achieve to carry an ATM stream.If set to '9999999', this parameter is ignored.
OBJECT-TYPE    
  Unsigned32 1..1000000 | 9999999  

gBondAtmDownMaxDataRate 1.3.6.1.2.1.211.1.1.1.1.1.2
The maximum net downstream data rate a bonding group is allowed to achieve to carry an ATM stream.If set to '9999999', this parameter is ignored.
OBJECT-TYPE    
  Unsigned32 1..1000000 | 9999999  

gBondAtmUpDiffDelayTolerence 1.3.6.1.2.1.211.1.1.1.1.1.3
The maximum upstream differential delay among member links in a bonding group.
OBJECT-TYPE    
  Unsigned32 0..8176  

gBondAtmDownDiffDelayTolerence 1.3.6.1.2.1.211.1.1.1.1.1.4
The maximum downstream differential delay among member links in a bonding group.
OBJECT-TYPE    
  Unsigned32 0..8176  

gBondAtmPortStatusTable 1.3.6.1.2.1.211.1.1.1.2
This table provides overall status information of G.Bond ATM ports, complementing the generic status information from the ifTable of IF-MIB and gBondFltStatus of GBOND-MIB. Additional status information about connected BCEs is available from the relevant line MIBs This table contains live data from the equipment. As such, it is NOT persistent.
OBJECT-TYPE    
  SEQUENCE OF  
    GBondAtmPortStatusEntry

gBondAtmPortStatusEntry 1.3.6.1.2.1.211.1.1.1.2.1
An entry in the G.Bond ATM port Status table. Each entry represents a G.Bond ATM port indexed by the ifIndex. Note that an G.Bond GBS port runs on top of a single or multiple BCE port(s), which are also indexed by ifIndex.
OBJECT-TYPE    
  GBondAtmPortStatusEntry  

gBondAtmShowTime 1.3.6.1.2.1.211.1.1.1.2.1.1
The accumulated time when a bonding group is in normal operation.
OBJECT-TYPE    
  TimeTicks  

gBondAtmUpRxCellLossCount 1.3.6.1.2.1.211.1.1.1.2.1.2
The total number of cells that are lost at aggregation output in the upstream direction from a bonding group for the accumulation interval.
OBJECT-TYPE    
  Counter32  

gBondAtmDownRxCellLossCount 1.3.6.1.2.1.211.1.1.1.2.1.3
The total number of cells that are lost at aggregation output in the downstream direction from a bonding group for the accumulation interval.
OBJECT-TYPE    
  Counter32  

gBondAtmGroups 1.3.6.1.2.1.211.1.2.1
OBJECT IDENTIFIER    

gBondAtmCompliances 1.3.6.1.2.1.211.1.2.2
OBJECT IDENTIFIER    

gBondAtmBasicGroup 1.3.6.1.2.1.211.1.2.1.1
A collection of objects representing management information for G.Bond ATM ports.
OBJECT-GROUP    

gBondAtmCompliance 1.3.6.1.2.1.211.1.2.2.1
The compliance statement for G.Bond ATM interfaces. Compliance with the following external compliance statements is REQUIRED: MIB Module Compliance Statement ---------- -------------------- IF-MIB ifCompliance3 GBOND-MIB gBondCompliance
MODULE-COMPLIANCE