FASTPATH-NSF-MIB

File: FASTPATH-NSF-MIB.mib (12741 bytes)

Imported modules

SNMPv2-SMI SNMPv2-TC SNMPv2-CONF
BROADCOM-REF-MIB FASTPATH-INVENTORY-MIB

Imported symbols

MODULE-IDENTITY OBJECT-TYPE Integer32
Counter32 Gauge32 Unsigned32
TimeTicks NOTIFICATION-TYPE TEXTUAL-CONVENTION
DisplayString TruthValue RowStatus
MODULE-COMPLIANCE OBJECT-GROUP NOTIFICATION-GROUP
fastPath agentInventoryUnitEntry agentInventoryUnitNumber

Defined Types

AgentNsfUnitEntry  
SEQUENCE    
  agentNsfUnitSupport TruthValue

Defined Values

fastPathNsf 1.3.6.1.4.1.4413.1.1.46
This MIB defines the objects used for FastPath to configure and report information and status of NSF features.
MODULE-IDENTITY    

agentNsfUnitTable 1.3.6.1.4.1.4413.1.1.46.1
A table of Per-Unit configuration objects for NSF.
OBJECT-TYPE    
  SEQUENCE OF  
    AgentNsfUnitEntry

agentNsfUnitEntry 1.3.6.1.4.1.4413.1.1.46.1.1
Each Instance corresponds with a different unit managed by this agent.
OBJECT-TYPE    
  AgentNsfUnitEntry  

agentNsfUnitSupport 1.3.6.1.4.1.4413.1.1.46.1.1.1
Indicates if the unit supports the NSF feature.
OBJECT-TYPE    
  TruthValue  

agentNsfGroup 1.3.6.1.4.1.4413.1.1.46.2
OBJECT IDENTIFIER    

agentNsfAdminStatus 1.3.6.1.4.1.4413.1.1.46.2.1
Controls whether NSF is enabled on the unit/stack.
OBJECT-TYPE    
  INTEGER enable(1), disable(2)  

agentNsfOperStatus 1.3.6.1.4.1.4413.1.1.46.2.2
Indicates whether NSF is enabled on the unit/stack.
OBJECT-TYPE    
  INTEGER enable(1), disable(2)  

agentNsfLastStartupReason 1.3.6.1.4.1.4413.1.1.46.2.3
The type of activation that caused the software to start the last time. unknown: The switch rebooted for an unknown reason. power-on: The switch rebooted. This could have been caused by a power cycle or an administrative 'Reload' command. warm-admin-move: The administrator issued a command for the stand-by manager to take over. cold-admin-move: The administrator issued a command for the stand-by manager to take over, but the system was not ready for a warm-failover. warm-auto-restart: The primary management card restarted due to a failure, and the system executed a nonstop forwarding failover. cold-auto-restart: The system switched from the active manager to the backup manager and was unable to maintain user data traffic. This is usually caused by multiple failures occurring close together
OBJECT-TYPE    
  INTEGER unknown(1), power-on(2), warm-admin-move(3), cold-admin-move(4), warm-auto-restart(5), cold-auto-restart(6)  

agentNsfTimeSinceLastRestart 1.3.6.1.4.1.4413.1.1.46.2.4
Time since the current management card became the active management card.
OBJECT-TYPE    
  TimeTicks  

agentNsfRestartInProgress 1.3.6.1.4.1.4413.1.1.46.2.5
Whether a restart is in progress. A restart is not considered complete until all hardware tables have been fully reconciled.
OBJECT-TYPE    
  TruthValue  

agentNsfWarmRestartReady 1.3.6.1.4.1.4413.1.1.46.2.6
Whether the initial full checkpoint has finished.
OBJECT-TYPE    
  TruthValue  

agentNsfBackupConfigurationAge 1.3.6.1.4.1.4413.1.1.46.2.7
Age of the configuration on the backup unit. The time since the running configuration was last copied to the backup unit.
OBJECT-TYPE    
  TimeTicks  

agentNsfInitiateFailover 1.3.6.1.4.1.4413.1.1.46.2.8
Triggers an administrative failover to the backup unit.
OBJECT-TYPE    
  INTEGER enable(1), disable(2)  

agentCheckpointStatsGroup 1.3.6.1.4.1.4413.1.1.46.3
OBJECT IDENTIFIER    

agentCheckpointClearStatistics 1.3.6.1.4.1.4413.1.1.46.3.1
When set to enable(1), resets checkpoint statistics.
OBJECT-TYPE    
  INTEGER enable(1), disable(2)  

agentCheckpointMessages 1.3.6.1.4.1.4413.1.1.46.3.2
Total number of checkpoint messages sent.
OBJECT-TYPE    
  Counter32  

agentCheckpointBytes 1.3.6.1.4.1.4413.1.1.46.3.3
Size in bytes of the total ammount of checkpoint messages sent.
OBJECT-TYPE    
  Counter32  

agentCheckpointTimeSinceCountersCleared 1.3.6.1.4.1.4413.1.1.46.3.4
Indicates how long since the Checkpoint counters have been cleared.
OBJECT-TYPE    
  TimeTicks  

agentCheckpointMessageRateInterval 1.3.6.1.4.1.4413.1.1.46.3.5
Indicates the duration in seconds of the message rate interval.
OBJECT-TYPE    
  Unsigned32  

agentCheckpointMessageRate 1.3.6.1.4.1.4413.1.1.46.3.6
Number of checkpoint messages received in the last interval defined by agentCheckpointMessageRateInterval.
OBJECT-TYPE    
  Gauge32  

agentCheckpointHighestMessageRate 1.3.6.1.4.1.4413.1.1.46.3.7
Highest number of checkpoint messages received in an interval defined by agentCheckpointMessageRateInterval.
OBJECT-TYPE    
  Gauge32  

agentNsfOspfGroup 1.3.6.1.4.1.4413.1.1.46.4
OBJECT IDENTIFIER    

agentNsfOspfSupportMode 1.3.6.1.4.1.4413.1.1.46.4.1
Tok_String
OBJECT-TYPE    
  INTEGER none(1), planned(2), always(3)  

agentNsfOspfRestartInterval 1.3.6.1.4.1.4413.1.1.46.4.2
Tok_String
OBJECT-TYPE    
  Unsigned32  

agentNsfOspfRestartStatus 1.3.6.1.4.1.4413.1.1.46.4.3
Tok_String
OBJECT-TYPE    
  INTEGER unknown(1), not-restarting(2), planned-restart(3), unplanned-restart(4)  

agentNsfOspfRestartAge 1.3.6.1.4.1.4413.1.1.46.4.4
Tok_String
OBJECT-TYPE    
  TimeTicks  

agentNsfOspfRestartExitReason 1.3.6.1.4.1.4413.1.1.46.4.5
Tok_String
OBJECT-TYPE    
  INTEGER none(1), in-progress(2), completed(3), timed-out(4), topology-change(5), manual-clear(6)  

agentNsfOspfHelperSupportMode 1.3.6.1.4.1.4413.1.1.46.4.6
Tok_String
OBJECT-TYPE    
  INTEGER none(1), planned(2), always(3)  

agentNsfOspfHelperStrictLSAChecking 1.3.6.1.4.1.4413.1.1.46.4.7
Tok_String
OBJECT-TYPE    
  INTEGER enable(1), disable(2)  

agentNsfTraps 1.3.6.1.4.1.4413.1.1.46.0
OBJECT IDENTIFIER    

agentNsfStackRestartComplete 1.3.6.1.4.1.4413.1.1.46.0.1
Sent when a the stack finishes restarting after a failover.
NOTIFICATION-TYPE