CTRON-DOWNLOAD-MIB

File: CTRON-DOWNLOAD-MIB.mib (11489 bytes)

Imported modules

RFC1155-SMI CTRON-MIB-NAMES RFC1213-MIB
RFC-1212

Imported symbols

NetworkAddress ctDownLoad DisplayString
OBJECT-TYPE

Defined Values

ctDL 1.3.6.1.4.1.52.4.1.5.8.1
OBJECT IDENTIFIER    

ctDLForceOnBoot 1.3.6.1.4.1.52.4.1.5.8.1.1
When set to a 1, the system will request a download during the next system restart. If no server is found and the current image in flash memory is valid, the system will boot using the flash-resident image.
OBJECT-TYPE    
  INTEGER  

ctDLCommitRAMToFlash 1.3.6.1.4.1.52.4.1.5.8.1.2
When written with a 1, the boot software will erase flash memory, compress the downloaded code if necessary, and save the image into flash memory. Upon completion of this operation, the flash memory driver resets this object to 0, indicating completion of the programming operation.
OBJECT-TYPE    
  INTEGER  

ctDLInitiateColdBoot 1.3.6.1.4.1.52.4.1.5.8.1.3
When written with a 1, the boot software initiates a system reboot. When written with a 2, the boot software initiates a soft reboot of the system. The soft reboot does not perform the Boot PROM Power-Up diagnostics. If only one form of reboot is supported initiate that reboot in both cases. A read always returns a 0.
OBJECT-TYPE    
  INTEGER  

ctDLTFTPRequestHost 1.3.6.1.4.1.52.4.1.5.8.1.4
The IP address of the TFTP server to be used when firmware is to be loaded across the network.
OBJECT-TYPE    
  NetworkAddress  

ctDLTFTPRequest 1.3.6.1.4.1.52.4.1.5.8.1.5
The filename requested of the server when firmware is to be loaded across the network.
OBJECT-TYPE    
  DisplayString  

ctDLLastImageFilename 1.3.6.1.4.1.52.4.1.5.8.1.6
The value of ctDLFileName during the last successful image download. This is the name of the file, on the TFTP server, that was download to become the current image.
OBJECT-TYPE    
  DisplayString  

ctDLLastServerIPAddress 1.3.6.1.4.1.52.4.1.5.8.1.7
The value of ctDLNetAddress during the last successful image download. This is the IP address of the TFTP server used to download the current image.
OBJECT-TYPE    
  NetworkAddress  

ctDLFlashSize 1.3.6.1.4.1.52.4.1.5.8.1.8
Denotes the size, in bytes, of flash memory contained on this module.
OBJECT-TYPE    
  INTEGER  

ctDLFlashCount 1.3.6.1.4.1.52.4.1.5.8.1.9
Denotes the number of times that flash memory has been reprogrammed. This value is initialized to 1, when the module is initially powered up.
OBJECT-TYPE    
  INTEGER  

ctDLFirmwareBase 1.3.6.1.4.1.52.4.1.5.8.1.10
Denotes the starting RAM address of the firmware.
OBJECT-TYPE    
  INTEGER  

ctDLFirmwareTop 1.3.6.1.4.1.52.4.1.5.8.1.11
Denotes the ending RAM address of firmware.
OBJECT-TYPE    
  INTEGER  

ctDLFirmwareStart 1.3.6.1.4.1.52.4.1.5.8.1.12
Denotes the RAM entry point of the firmware as established by the boot process.
OBJECT-TYPE    
  INTEGER  

ctDLBootRev 1.3.6.1.4.1.52.4.1.5.8.1.13
Denotes the revision of boot firmware in the module. The first octet provides the version, and the second provides the revision.
OBJECT-TYPE    
  OCTET STRING Size(9)  

ctDLForceBootp 1.3.6.1.4.1.52.4.1.5.8.1.14
When set to 1, this object forces the client to send a BOOTP request packet when rebooting. The client will make several attempts before timing out if a BOOTP server does not respond. This object remains set.
OBJECT-TYPE    
  INTEGER  

ctDLServerName 1.3.6.1.4.1.52.4.1.5.8.1.15
This OID is reserved for future use of the BOOTP server name. This field can be used when a client wants to get boot information from a particular BOOTP server.
OBJECT-TYPE    
  OCTET STRING  

ctDLOnLineDownLoad 1.3.6.1.4.1.52.4.1.5.8.1.16
During normal operation this object has the value of 1. By setting this object to a value of forceDownLoad(2) an image download via TFTP will be performed, ctDLNetAddress specifies the TFTP server and ctDLFileName specifies the file name of the image on the TFTP server. By setting this object to a value of forceDownLoadReset(3) an image download via TFTP will be performed, ctDLNetAddress specifies the TFTP server and ctDLFileName specifies the file name of the image on the TFTP server. A reset will be forced upon successful completion of the download. By setting this object to a value of downLoadConfiguration(4) the specified configuration file will be downloaded, verified, and, if valid, committed to NVRAM, if valid. A reset will be forced upon successful completion. ctDLNetAddress specifies the TFTP server and ctDLFileName specifies the name of the configuration file on the TFTP server. By setting this object to upLoadConfiguration(5), the contents of NVRAM will be uploaded via TFTP to the specified file on the specified TFTP server. ctDLNetAddress specifies the TFTP server and ctDLFileName specifies the name of the configuration file.
OBJECT-TYPE    
  INTEGER normalOperation(1), forceDownLoad(2), forceDownLoadReset(3), downLoadConfiguration(4), upLoadConfiguration(5)  

ctDLOperStatus 1.3.6.1.4.1.52.4.1.5.8.1.17
This object reflects the status of the download code. normalOperation(3) - Indicates that either no download has been started, or that a download was started and has finished normally. downLoadActive(4) - indicates a download is currently in progress. downLoadCompleteError(5) - Indicates that a download was started but an error was detected.
OBJECT-TYPE    
  INTEGER other(1), unknown(2), normalOperation(3), downLoadActive(4), downLoadCompleteError(5)  

ctDLNetAddress 1.3.6.1.4.1.52.4.1.5.8.1.18
The IP Address of the TFTP server to be used for uploading and downloading configuration files and for downloading images.
OBJECT-TYPE    
  NetworkAddress  

ctDLFileName 1.3.6.1.4.1.52.4.1.5.8.1.19
The file name to be used to specify the image or configuration file on the TFTP server specified by ctDLNetAddress. This should be a complete path filename.
OBJECT-TYPE    
  DisplayString Size(0..128)  

ctDLErrorString 1.3.6.1.4.1.52.4.1.5.8.1.20
If the value of ctDLOperStatus is downloadCompleteError(5) then this object will provide a more complete description of the error. Otherwise this object will be the zero length string.
OBJECT-TYPE    
  DisplayString  

ctDLTftpServerGatewayIPAddress 1.3.6.1.4.1.52.4.1.5.8.1.21
The IP address of the gateway/router which connects this SNMP agent to the TFTP server.
OBJECT-TYPE    
  NetworkAddress  

ctDLBlockCount 1.3.6.1.4.1.52.4.1.5.8.1.22
Current TFTP block count of an active session. If no TFTP transfer is in progress, zero is returned.
OBJECT-TYPE    
  INTEGER  

ctDLBootPartitionStatus 1.3.6.1.4.1.52.4.1.5.8.1.23
Status of the boot partition or partitions. A value of good(1) indicates that all boot partitions contain a valid checksum. A value of bad(2) indicates that one or more boot partitions contain an invalid checksum and the the image was not able to fix the invalid boot partition. A value of inProgress(3) indicates that the image is attempting to fix an invalid boot partition and this status will change to either good(1) or bad(2).
OBJECT-TYPE    
  INTEGER good(1), bad(2), inProgress(3)