Reason: A communications error occurred when a rule
evaluator attempted to send a request back
to the security engine master daemon.
Action: Verify the status of IPC facilities on your
Reason: A Main Monitor function has encountered more
than ten consecutive CAICCI failures. This
message is a warning of possible network
Action: Investigate CAICCI and network status.
Reason: Workload monitor attempted to submit a job,
but found that a required resource is not
defined in any global or station resource
Action: Either add the resource to a global or
station table, or remove the resource
requirement for the job.
Reason: Workload monitor received a failure record
from the CAIENF tracking function on a
Action: Review the logs SCHDEN2.nnnn and SCHDEN4.nnnn
to determine the cause of failure.
Reason: Workload remote tracking task discovered that
CAIENF is not active on the specified node.
This means that no tracking data is being
recorded on that node.
Action: Start the CAIENF tracking task on this node.
Reason: The GUI main message router (CaMRouter) has
Action: Use the uniclean command and then restart
the GUI main message router with the command
Reason: A resident tape volume, whose volume serial
number matches the volume serial number requested,
was mounted in response to a request for a
Action: Mount the nonresident tape volume.
Reason: The tape volume that was mounted in response
for a scratch tape has a nonblank LOCATION
in the corresponding volume definition in DB.
Action: Mount a different scratch tape.
Reason: The first 17 chars of the file name stored on
the tape's header HDR1 label do not match
those in the FILE17 field in the corresponding
Action: Verify the labels.
Reason: Either the age threshold or error threshold
has been exceeded for the tape volume mounted,
causing the volume to be flagged as a bad tape
in the DB.
Action: Mount a valid scratch tape.
Reason: An attempt was made to initialize or mount a
tape volume that is defined to the Tape Mgmt
DB but is not in active service.
Action: Use the CATAPE ACTIVE VOLUME control statement
to place the tape volume in active service.